RADIO
You can use this set solely as a radio!
1
Adjust
RADIO ON/OFF
to
ON
to switch on the radio.
2
Select your waveband by adjusting the BANDswitch
.
3
Adjust TUNINGto tune to your desired station
.
4
Turn the VOLUMEcontrol to adjust the volume level
.
5
Adjust
RADIO ON/OFF
to OFFto switch off the radio.
To improve reception:
FM: extend and
position the pigtail for optimum reception
.
AM (MW):
uses a built-in aerial inside the set. Direct the aerial by
adjusting the position of your set
.
SETTING THE CLOCK ANDALARM TIME
The time is displayed using the 12-hour clock
IMPORTANT!
To adjust the clock and alarm times accurately, always make sure
you press
UP / DOWN
separately and not simultaneously.
1
Turn the clock controlto SET TIME or SET AL 1 or SET AL 2 to set the
clock or alarm time respectively.
2
Press
UP / DOWN
repeatedly or hold down on the respective button to adjust
the hours and minutes.
3
Release
UP / DOWN
when you reach the correct setting.
4
After you have set both the hour and minutes, turn the clock controlto
CLOCKto run on clock time.
SELECTING THE ALARMMODE
GENERAL
If you wish to use the alarm, you must first set the alarm time first. You can
choose from two different alarm modes to wake you up: by radio or buzzer.
•
Select your choice of alarm mode by adjusting AL 1or AL 2 to RADIO or
BUZ.
™
The buzzers are at a set volume and cannot be adjusted. BUZ on AL 1is a
low tone buzzer while BUZ on AL 2is a high tone.