No sound.
–Volume not adjusted.
•Adjust the VOLUME.
CD playback does not work.
–CD badly scratched or dirty.
•Replace/ clean CD.
–Laser lens steamed up.
•Wait until lens has adjusted to room temperature
–Laser lens dirty.
•Clean lens by playing a CD lens cleaning disc.
–CD-R is non-finalized.
•Use a finalized CD-R.
Occasional crackling sound during FM
broadcast.
–Weak signal.
•Extend the pigtail antenna fully.
Continuous crackling/ hiss disturbance
during MW broadcast.
–Electrical interference from TVs,computers,
fluorescent lamps,etc.
•
Move set away from other electrical equipment
The alarm does not function.
–Alarm time not set.
•
See section on Setting alarm time
.
–Alarm mode not selected.
•
See section on Setting alarm mode
.
–No CD is inserted as CD is selected as Alarm
mode.
•
Insert a CD.
Troubleshooting If a fault occurs,first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints,consult your dealer or
service center.
WARNING:Do not open the set as there is a risk of electric shock. Under no circum-
stances should you try to repair the set yourself,as this will invalidate the warranty.