Philips AJ 3280 manual Controls Installation, See fig

AJ3280/00 page 4

CONTROLS INSTALLATION RADIO

English

FRONT PANELS See fig. 1

1SLUMBER

–to activate radio for slumber

2 ALARM RESET

–to stop the active alarm for 24 hours

3SET CONTROL

–RUN

To return to clock time display after setting clock/alarm times

–ALARM 1

To adjust/review ALARM 1

–ALARM 2

To adjust/review ALARM 2

–TIME SET

To adjust clock time

–7, 4 (fast up, slow down)

To adjust both the hours and minutes for the clock and alarm times

4SLUMBER OFF / REPEAT ALARM

–to switch off slumber

–to stop the active alarm for a 6 minute

period

5Display

–with alarm indicators

6 TUNING

–to tune to radio stations

7 BAND

–to select FM-MW (LW) band

8 VOLUME

–to adjust the sound level

BACK PANEL See fig. 2

9RADIO

–to switch radio mode ON/OFF

0 ALARM 2:

–OFF

to switch off alarm 2

–RAD (io)

to activate radio for alarm 2 setting

–BUZ (zer)

to activate buzzer for alarm 2 setting

!ALARM 1:

–OFF

to switch off alarm 1

–RAD (io)

to activate radio for alarm 1 setting

–BUZ (zer)

to activate buzzer for alarm 1 setting

@Mains lead

–for AC mains supply

#Battery compartment

–for power battery backup $ Pigtail aerial - for FM reception

MAINS CONNECTION

1.Check if the mains voltage as shown on the type plate on the base of the set corresponds to your local mains supply.

2.Connect the mains plug into the wall socket. The mains supply is now switched on and the numbers on the display will start to flash. You will need to set the correct time.

3.To disconnect the set from the mains completely, withdraw the mains plug from the wall socket.

For users in the U.K.: please follow the

instructions on page 2.

FM/MW (LW) RADIO

You can use the clock radio solely as a radio.

1.Set the RADIO switch to ON.

2.Select your waveband using the BAND switch.

3.Use TUNING to find your radio station.

4.Adjust the sound with the VOLUME control.

5.To turn off the radio, set the RADIO switch to OFF.

To improve radio reception

–For MW (or LW), the set is provided with a built-in aerial which to function best should be placed on a non-metallic surface e.g. wood, plastic. Direct the MW aerial by adjusting the position of your clock radio.

–For FM reception extend the pigtail aerial at the back of the set completely to obtain optimum reception.

4