Philips AJ 3280 manual Alarm /SLUMBERING Additional, Maintenance, Slumber, Power Breakdown Backup

Models: AJ 3280

1 49
Download 49 pages 51.28 Kb
Page 6
Image 6

 

 

AJ3280/00 page 6

 

 

ALARM /SLUMBERING

ADDITIONAL

 

 

 

 

 

 

English

If, however, you do not press SLUMBER

OFF/REPEAT ALARM again, the alarm will sound for 59 minutes before turning itself off. Your alarm time setting will then automatically enter the ALARM RESET mode to sound at the same time next day.

Switching off the alarm completely

Before or during the set alarm goes off, push the ALARM (1 or 2) switch to the OFF position.

The alarm indicator will disappear from the display.

MAINTENANCE

If you do not intend to use the clock radio for a long time, disconnect the set by removing the plug from the wall socket. The battery should also be removed to prevent chemical leakage which will damage your set.

To clean your set from fingerprints, dust and dirt, use a clean and soft damp cloth or chamois leather. Do not use cleaning products which contain benzene, thinner etc. as these may harm the housing.

SLUMBER

The clock radio has a built-in timer device called the SLUMBER, which enables the radio to be automatically switched off after 59 minutes; this allows you to lie back, listen and fall asleep.

SLUMBER ON

1.Set the RADIO switch to the OFF position.

2.Set your slumber time by pressing on the SLUMBER button. Keep your finger on the button and the display will begin to count down from 59 to 00 minutes.

3.Release the button as soon as the required slumber time is reached.

SLUMBER OFF

You can switch off the radio before the slumber time has elapsed:

To cancel the SLUMBER function, press

SLUMBER OFF/REPEAT ALARM.

Notes:

The slumber function does not affect the alarm setting (s).

If during SLUMBER you have turned down the volume and you have an alarm set in radio mode, make sure you have adjusted the volume loud enough to wake you up the next day.

POWER BREAKDOWN BACKUP

When a power failure occurs, the complete clock radio will be switched off.

As soon as the mains supply returns, the numbers on the display will start to flash. This indicates that you must set the correct time on the clock.

To retain the clock time and the set alarm time

(s) in the event of a power failure or disconnection, insert a 9 volt battery, type 6F22 (not supplied) into the battery compartment: this will act as a power back up. However, the time will not be illuminated on the clock display. Operation of the alarm(s) and radio are also excluded.

For clarity, the battery back up is used to retain the set clock and alarm time (s) only. As soon as the mains supply returns, the

display will indicate the correct time.

Before inserting the battery, connect the mains plug to the wall socket.

Insert a battery into the battery compartment.

– Replace the battery once a year or as often as necessary.

Batteries contain chemical substances, so they should be disposed of properly

6

Page 6
Image 6
Philips AJ 3280 manual Alarm /SLUMBERING Additional, Maintenance, Slumber, Power Breakdown Backup