Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.
Problem
–Possible cause
• Remedy
No sound /power
–Volume not adjusted
• Adjust the VOLUME
–Power cord not securely connected
•Connect the AC power cord properly
– Batteries dead/ incorrectly inserted
•Insert (fresh) batteries correctly
–Headphones connected to the set
• Disconnect headphones.
Display does not function properly/ No reaction to operation of any of the controls
–Electrostatic discharge
•Switch off and unplug the set. Reconnect after a few seconds
Severe radio hum or noise
–Electrical interference: set too close to TV, VCR or computer
•Increase the distance
Poor radio reception
–Weak radio signal
•FM: Adjust the FM telescopic antenna
•MW: Direct this antenna for best reception by turning the whole set.
Poor cassette sound quality
–Dust and dirt on the heads, etc.
• Clean deck parts, see Maintenance
–Use of incompatible cassette types (METAL or
CHROME)
• Only use NORMAL (IEC I) for recording
Recording does not work
–Cassette tab(s) may be broken
• Apply adhesive tape over the missing tab space
Environmental information
All unnecessary packaging material has been omitted.The packaging can be easily separated into three materials: cardboard, polystyrene and plastic.
Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging, dead batteries and old equipment.
