Power Supply | General Operation/ Radio |
Using AC power
1Check if the power voltage, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center.
2If your set is equipped with a voltage selector, adjust the selector so that it matches with the local mains.
3Connect the power cord to the AC INPUT inlet and the wall socket.The power cord is now connected and ready for use.
4To switch the set off completely, withdraw the power cord from the wall socket.
•Disconnect the power cord from the wall socket to protect your set during heavy thunderstorms.
Helpful hints : To avoid unnecessary energy consumption, always adjust the Source selector to TAPE after using the set. Also check that the tape deck keys are released.
The type plate is located on the bottom of the set.
CAUTION
Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation.
General operation
Switching on and off and selecting functions
1To switch on, push the Source selector slider to TAPE or RADIO as desired.
2To switch off, push the Source selector to TAPE and check the cassette keys are
released.
Helpful hints:
–To change from TAPE to RADIO , or when you are switching off the set: first, make sure you press the STOP•EJECT 9/ key to end playback and all the cassette keys are released.
Adjusting volume
•Adjust the volume with the VOLUME control.
Radio reception
1Adjust the source selector to RADIO.
2Adjust the band selector to select your desired waveband, MW or FM.
3Turn TUNING to tune to a station.
- FM STEREO lights up for stereo FM reception.
4To switch off the radio, adjust the source selector to TAPE position.
To improve radio reception:
•For FM, extend and turn the telescopic antenna for best reception. Reduce its length if the signal is too strong.
•For MW, the set uses a
