Philips AX5003/10 manual Power Supply

English

POWER SUPPLY

Batteries (supplied or optionally available)

You can use the following batteries with this CD-player:

•normal batteries type LR6, UM3 or AA (preferably Philips), or

•alkaline batteries type LR6, UM3 or AA (preferably Philips).

Note: – Old and new or different types of batteries should not be used in combination. Remove batteries if they are empty or if the player is not going to be used for a long time.

Inserting batteries

1 Push OPEN 2 to open the CD lid.

2 Open the battery compartment and insert either

2 normal or alkaline batteries, or the rechargeable NiMH battery AY 3362 (if supplied).

Battery indication

The approximate power level of your batteries is shown in the display.

Battery full

Battery two-thirds full

Battery one-third full Battery dead or empty. When the batteries are

dead or empty, the symbol A flashes, bAtt is displayed, and the beep tone sounds repeatedly.

Average playing time of batteries under normal conditions
Battery type	ESP on		ESP off
Normal	7	hours	6	hours
Alkaline	22	hours	19	hours
Rechargeable ECO-PLUS NiMH battery	10	hours	9	hours

Batteries contain chemical substances, so they should be disposed of properly.

POWER SUPPLY

ECO-PLUS NiMH battery information (for versions supplied with

the rechargeable ECO-PLUS NiMH battery AY 3362)

Recharging works only on players supplied with the rechargeable ECO-PLUS NiMH battery AY 3362.

Recharging the ECO-PLUS NiMH battery on board

1Insert the rechargeable ECO-PLUS NiMH battery AY 3362.

2Connect the mains adapter to the 4.5V DC socket of

the player and then to the wall socket.

y A is shown and ChArGE is displayed for 5 seconds.

• Recharging stops after a maximum of 7 hours, or when you start playback.

3When the battery is fully recharged, and

FULL appear briefly in the display, before the display switches off.

Notes: – It is normal for the batteries to become warm during recharging.

–If the batteries become too warm, recharging will be interrupted for approximately 30 minutes and Hot is displayed.

–To ensure proper recharging on board, take care that contacts are clean.

–Use only the ECO-PLUS NiMH battery AY 3362.

Handling instructions

•Recharging already charged or half-charged batteries will shorten their lifetime. We therefore recommend that you let the rechargeable ECO-PLUS NiMH battery run till it is completely empty before you recharge it.

•To avoid a short circuit, do not let the battery touch any metal object.

•If the battery becomes empty soon after recharging, then either its contacts are dirty or it has reached the end of its lifetime.

English

8 9