• Incorrect use of batteries can cause
electrolyte leakage and will corrode the
compartment or cause the batteries to burst:
• Do not mix battery types: e.g. alkaline with
carbon zinc. Only use batteries of the same
type for the set.
• When inserting new batteries, do not try to
mix old batteries with the new ones.
• Remove the batteries if the set is not to be
used for a long time.
Using AC Mains
1 Check if the power/mains voltage, as shown
on the type plate located on the
bottom of the set, corresponds to your
local power supply. If it does not, consult your
dealer or service center
2 If your set is equipped with a voltage selector,
adjust the selector so that it matches with the
local mains.
3 Connect the power cord to the AC MAINS
inlet and the wall socket.The mains lead is
now connected and ready for use.
4 To switch the set off completely, withdraw the
power cord from the wall socket.
•Disconnect the mains lead from the wall
socket to protect your set during heavy
thunderstorms.
The type plate is located on the bottom
of the set.
Helpful hints : To avoid unnecessary energy
consumption, always adjust the source
selector to
TAPE/OFF
after using the set.
Also check that the tape deck keys are
released.
General operation
1 To select your sound source adjust the
source selector to : CD,MW,FM or
TAPE/OFF
.
2 Adjust the sound with the VOLUME
control.
3To switch off the set, adjust the source selec-
tor to
TAPE/OFF
position and check the
cassette keys are released.
Radio reception
1 Adjust the source selector to
MW or
FM
.
2Tu r n TUNING to tune to a station.
• For FM,extend and turn the telescopic
antenna for best reception. Reduce its length
if the signal is too strong.
• For MW,the set uses a built-in antenna.
Direct this antenna for best reception by
turning the whole set.
3To switch off the radio, adjust the source
selector to
TAPE/OFF
position and check
the cassette keys are released.
Power Supply General operation/Radio
AZ1006-Eng 3/25/05 14:28 Page 6