Philips AZ1055 manual Basic Functions, Switching the set on and off, Adjusting volume and sound

BASIC FUNCTIONS RADIO

Switching the set on and off

English

Set the POWER slider to the desired sound source: CD, TAPE, or BAND (for radio).

The set is switched off when the POWER slider is set to OFF/TAPE and the keys of the tape deck are released.

Note: If you use batteries, switch the set off after use. This will avoid unnecessary power consumption.

OFF
POWER	TAPE FM
	CD	AM
DYNAMIC
	BASS
		BOOST
		CD	AZ1055
			RADIO
			CASSETTE R

Adjusting volume and sound

Adjust the volume using the VOLUME control.

Increase and decrease the bass level by pressing DBB.

The bass level can also be emphasised if you place the set against wall or shelf. Do not cover any vents; leave sufficient room around the unit for ventilation.

DYNAMIC
BASS
BOOST
CD	AZ1055
	RADIO
	CASSETTE
VOLUME

Radio – tuning to radio stations

1Set the POWER slider to FM or MW to select the desired wave band.

2Tune to the desired radio station by using the TUNING wheel.

Improving RADIO reception

For FM stations, pull out the telescopic antenna. To improve the signal, incline and turn the antenna. Reduce its length if the signal is too strong (very close to a transmitter).

For MW stations, direct the built-in antenna by turning the whole set. The telescopic antenna is not needed.

									FM AM
								108
			Y						170
	D S
			NCH		RO
C						ST		104	130
						AR
						T
						R	100		100
						E
						C
						O	96		80
						R
						D
						I
						N	92
		AZ1055				G		63
CD
	RADIO CASSETTE			RECORDER
							88	53
							MHz	kHz
								x 10
						PE
						N•CL
						OS

6