Philips AZ1122, AZ1123 owner manual English, Power Supply General Operation/Tuner

English Controls/Power Supply

Power Supply General Operation/Tuner

Supplied Accessories	CAUTION
– AC power cord	Use of controls or adjustments or
	performance of procedures other
	than herein may result in unsafe
Top/front panels (See 1)
	operation.

Using AC power

WARNING: Always check you have completely switched off the set, before you change or disconnect power supply.

1 Check if the power voltage, as shown on

the type plate located on the

General operation

Switching on and off and selecting the function

1 To select your sound source, adjust the

Source selector to: CD, FM or AM.

1Source selector: CD, FM, AM or OFF

–selects CD or radio (FM/MW) source of sound

–power off switch

2 2; – starts or pauses CD playback § ∞

–selects the next/previous track

–fast searches forwards/backwards (press and hold the button)

PROG – programs tracks and reviews the program

9– stops CD playback;

– erases a CD program

3Display – shows the CD functions

4REPEAT – repeats a track/

CD program/entire CD.

Power Supply

Whenever convenient, use the power supply cord if you want to conserve battery life. Make sure you remove the plug from the set and wall outlet before inserting batteries.

Batteries (not included)

1Open the battery door and insert 6 batteries, type R-14, UM-2or C-cells, (preferably alkaline) with the correct polarity as indicated by the "+" and "–" symbols inside the com- partment (See 1).

2Replace the battery door, making sure the bat- teries are firmly and correctly in place.The set is now ready to operate.

	bottom of the set, corresponds to your
	local power supply. If it does not, consult your
	dealer or service center.
2	Connect the power cord to the
	AC MAINS~ inlet and the wall socket.The
	set is now connected and ready for use.
3	To switch the set off completely, withdraw the
	power cord from the wall socket.
4	Install the unit near the AC outlet and where
	the AC power plug can be easily reached.

•Disconnect the power cord from the wall socket to protect your set during heavy thunderstorms.

The type plate is located on the bottom of the set.

2 To switch off the set, adjust the

Source selector to OFF position.

Adjusting volume

Adjust the sound with the VOLUME control.

Radio reception

1Adjust the Source selector to FM or AM to select your desiredwaveband.

2Turn TUNING to tune to a station.

Helpful hints:

To improve radio reception

• For FM, extend, incline and turn the

telescopic antenna for best reception. Reduce

5SHUFFLE – plays all tracks in random order

6OPEN•CLOSE – opens/ closes the CD door

7TUNING – tunes to radio stations

8VOLUME – adjusts volume level

•Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst:

•Do not mix battery types: e.g. alkaline with car- bon zinc. Only use batteries of the same type for the set.

•When inserting new batteries, do not try to mix old batteries with the new ones.

Helpful hints:

–To avoid unnecessary energy consumption, always adjust the Source selector to OFF after using the set.

its length if the signal is too strong.

• For AM, the set uses a built-in antenna.

Direct this antenna for best reception by

turning the whole set.

Back/bottom panels (See 1)

9Telescopic antenna – improves FM reception

0Battery door – open to insert 6 x 1.5V R-14/UM-2/C-cells

•Remove the batteries if the set is not to be used for a long time.

Batteries contain chemical substances, so they should be disposed of properly.

!p – 3.5 mm stereo headphone socket Helpful hints: The speakers will be muted when headphones are connected to the set.

@AC MAINS~ – inlet for power cord