English | CONTROL |
POWER SUPPLY | BASIC FUNCTIONS |
ACCESSORIES
1 x AC mains lead
1 x Remote Control
TOP AND FRONT PANEL (See 1)
1PROGRAM
CD: - programs tracks and reviews the program;
Tuner: - programs preset radio stations.
2CD•FM•MW•LW - selects CD / FM / MW / LW function
3IR SENSOR - infrared for remote control
4TUNER PRESET 4 ,3 - selects a preset radio station.
5OPEN•CLOSE - opens / closes CD door.
6Telescopic antenna - improves FM reception.
7VOLUME +, - - to adjust volume level.
8DBB (Dynamic Bass Boost) - activates a more vivid bass response.
9 2; - starts or pauses CD playback. |
9 - to stop playback or erase a CD program. |
SEARCH ∞ , § |
CD: - searches backward and forward within a track; |
REMOTE CONTROL (See A)
1CD – selects CD sound source
2y – switches the set to standby / on if set operating on AC power. (Switches set off only if battery powered)
-– adjusts volume level (up, down)3 VOLUME +,
4SHUFFLE – plays all CD tracks in random order 5BASS – selects DBB on/off
62; – starts/ pauses CD playback
7SEARCH 5, 6 – searches backwards/ forwards within a track
8BAND – selects FM/MW/LW waveband
9PRESET 3, 4 – selects a preset radio station (up, down)
0TUNING ∞, § – tunes to tuner stations (down, up)
!TUNER – selects tuner sound source @9 – stops CD playback;
– erases a CD programme
#¡, ™ – skips to the beginning of a current track previous/ subsequent track
$MUTE – interrupts/ resumes sound
%REPEAT – repeats a track /programme/ entire CD
CAUTION
Use of controls or adjustments or performance of procedures other than
IMPORTANT !
•Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst.
•Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set.
•When inserting new batteries, do not try to mix old batteries with the new ones.
•Batteries contain chemical substances, so they should be disposed of properly.
Using AC Power
1.Check if the AC power supply, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service centre.
2.Connect the mains lead to the wall socket.
3.To disconnect the mains supply, unplug the set from the wall socket.
Storing your remote control
Placing your set
To avoid possible staining of surfaces, please do not stand this set in vertical position over a long period.
The type plate is located on the bottom of the set.
This set complies with the radio interference requirements of the European Community.
For users in the U.K., please follow the boxed instructions ‘Important notes...’ on this sheet.
BASIC FUNCTIONS
Switching on and off and selecting function
1.Press POWER on the set (or y on remote control) to switch on.
2.Press CD•FM•MW•LW once or more to select : CD / Tuner function, and operate the respective function controls.
- skips to the beginning of a current track/ |
previous/ later track. |
Tuner: - (down, up) tunes to radio stations.
0POWER - power on / off switch
!MODE - selects different play modes: e.g. REPEAT or SHUFFLE (random) order.
@Display - shows the status of the set.
BACK PANEL (See 1)
#AC MAINS - inlet for mains lead.
$Battery compartment - for 6 batteries, type
herein may result in hazardous radiation exposure or other unsafe operation.
POWER SUPPLY
Whenever convenient, use the AC power supply to conserve battery life. Make sure you remove the power plug from the set and wall socket before inserting batteries.
Batteries (not included)
•Insert 6 batteries, type
•Remote control
Insert 2 batteries, type AAA, R03 or UM4 (preferably alkaline). (See 8)
This set has a special
3.Press POWER to switch off the set.
Note : The DBB setting, tuner presets and the volume level (maximum to 20) will be retained in the set's memory.
Adjusting volume and sound (See 2)
1.Adjust the volume with the VOLUME +, - controls.
™Display shows the volume level in number from
2.Press DBB once or more to select dynamic bass boost on or off.
™Display: shows 
when activated.
