Philips AZ4000 Troubleshooting, Problem, Solution, No sound/ power, CD playback does not work

XP AZ 4000/00-1 19-11-2001 12:10 Pagina 17

Troubleshooting

If a fault occurs, first check the points listed below before taking the set for repair. Do not open the set as there is a risk of electric shock.

If you are unable to remedy a problem by following these hints, consult your dealer or service center.

WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty.

English

Problem	Solution
No sound/ power	– Volume not adjusted.
	Adjust the VOLUME
	– Power cord not securely connected.
	Connect AC power cord properly.
	– Batteries dead/ incorrectly inserted.
	Insert (fresh) batteries correctly.

Display does not function properly/ No reaction to operation of any of the controls

–Electrostatic discharge. Switch off and unplug the set. Reconnect after a few seconds.

INSERT CD or CHECK DISC indication

–No CD inserted. Insert a CD.

–CD badly scratched or dirty.

Replace/ clean CD (see Maintenance).

–Laser lens steamed up. Wait until lens has cleared

–CD-R(W) is blank or the disc is not finalized. Use a finalized CD-R(W).

CD playback does not work	– CD badly scratched/ dirty.
	Replace/ clean CD (see Maintenance).
	– Laser lens steamed up.
	Wait until lens has acclimatized.
The CD skips tracks	– Disc damaged or dirty.
	Replace or clean disc.
	– SHUFFLE or a program is active.
	Quit SHUFFLE / program mode(s).

17