MAINTENANCE
PRECAUTIONS AND SYSTEM MAINTENANCE
•Place the set on a hard, flat surface so that the system does not tilt.
•Do not expose the set, CDs, batteries or cassettes to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight.
•Do not cover the set. Adequate ventilation with a minimum gap of 15 cms between the ventilation holes and surrounding surfaces is necessary to prevent heat
•The mechanical parts of the set contain
•To clean the set, use a soft, slightly dampened chamois leather. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing.
CD player and CD handling
•The lens of the CD player should never be touched.
•Sudden changes in the surrounding temperature can cause condensation to form and the lens of your CD player to cloud over. Playing a CD is then not possible. Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates.
•Always shut the CD door to keep the CD compartment dust- free. To clean, dust the compartment with a soft dry cloth.
•To take a CD out of its box, press the center spindle while lifting the CD. Always pick up the CD by the edge and replace the CD back in its box after use to avoid scratching and dust.
•To clean the CD, wipe in a straight line from the center towards the edge using a soft,
•Never write on a CD or attach stickers to it.
Tape deck maintenance
To ensure a good recording and playback of the tape deck, clean parts A,B and C show in the diagram below, after approx. 50 hours of operation, or on average once a month. Use a cotton bud slightly moistened with alcohol or a special head cleaning fluid to clean both decks.
1.Open the cassette holder by pressing STOP•OPEN 9/.
2.Press PLAY 1 and clean the rubber pressure rollers C.
3.Press PAUSE ; and clean the magnetic heads A and also the capstans B .
4.After cleaning, press STOP•OPEN 9/.
Note: Cleaning of the heads can also be done by playing a cleaning cassette through once.
X
A A B C
English
15
