TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty.
English
PROBLEM
–POSSIBLE CAUSE
• REMEDY
No sound/power
–VOLUME not adjusted
• Adjust the VOLUME
–Headphones connected
• Disconnect headphones
–Power cord not securely connected
• Connect AC power cord properly
Severe radio hum or noise
The CD skips tracks
–CD damaged or dirty
• Replace or clean CD
–SHUFFLE or PROGRAM is active
• Switch off SHUFFLE / PROGRAM
Poor cassette sound quality
–Dust and dirt on the heads, etc.
• Clean deck parts, see Maintenance
–Use of incompatible cassette types (METAL
or CHROME)
• Only use NORMAL (IEC I) for recording
– Electrical interference: set too close to TV, |
| Recording does not work |
VCR or computer |
| – Cassette tab(s) may be broken |
• Increase the distance |
| • Apply a piece of adhesive tape over the |
Poor radio reception |
| missing tab space. |
|
|
–Weak radio signal
•FM: Direct the FM telescopic aerial for optimum reception
indication
–CD badly scratched or dirty
•Replace/ clean CD, see Maintenance
– Laser lens steamed up
•Wait until lens has cleared
indication
–
• Use a finalized
The type plate is located on the bottom of the set.
17
