Mounting the Bracket and the Camera
1.Using the included template as a guide, make a hole (φ 240 mm) in the ceiling.
Template
2.Drive an anchor bolt (not included) into the original ceiling and attach a nut (not included) to the bolt.
•Drive the anchor bolt into the original ceiling directly above the center of the hole made in step 1.
•The end of the anchor bolt should be 47 mm above the bottom of the ceiling board.
•The bottom of the nut should be 61 mm above the bottom of the ceiling board.
Anchor bolt |
Nut |
47 mm 61 mm
Ceiling board
Bolt is above center of hole
3.Secure the safety wire to the bracket using screw B (included).
Screw B
Safety wire
4.Insert the bracket into the hole in the ceiling.
•The camera will face the direction indicated by the arrow on the bracket.
5.Tighten the 3 clamp screws (attached to the bracket) and secure the bracket.
•The clamps tighten as the screws are tightened.
Clamp screw |
Clamp |
Ceiling board
Clockwise
6.Secure the bracket by attaching and tightening a nut (not included) to the anchor bolt.
Nut
7.Secure the safety wire (included with the camera) to the camera using screw B (included with the camera) and washer B (included with the camera).
•Make sure you attach the safety wire when mounting the camera on a ceiling to prevent the camera from falling.
Screw B (Length: 10 mm,
Body diameter: 2.6 mm)
Washer B 
(Inside diameter: 2.6 mm) Safety wire 
Safety wire hole
8.Align the 2 round protrusions on the camera and the holes on the ceiling plate (included with the camera), tighten the screw to secure the ceiling plate, then pass the safety wire through the ceiling plate as shown. Make sure you do not scratch the lens cover when performing this procedure.
Screw A (2 pcs.) (Length: 20 mm,
Body diameter: 4.0 mm)
Holes
4
