Philips CCA092AT owner manual Hooking Up the TV/VCR cont’d, Mobile Connections, Car battery cord

Models: CCA092AT

1 52
Download 52 pages 39.71 Kb
Page 8
Image 8

8 Hooking Up the TV/VCR (cont’d)

Mobile Connections

Usually, the supplied indoor rod antenna pro- vides adequate reception. But when you want to watch TV outdoors or in a vehicle, use a mobile antenna (not supplied) or an indoor dipole antenna (not supplied) and a car battery cord (supplied) to get good reception.

1

Connect an antenna to the ANT(enna) jack. Refer to the instructions with your mobile antenna to make a connection similar to this one.

2

Make sure your vehicle has a 13.2-volt, negative ground electrical system. Connect one end of the car battery cord to the DC 13.2V jack on the back of the TV/VCR. Then connect the other end of the car battery cord to the cigarette lighter in your vehicle.

Mobile Antenna

(not supplied)

ANT.

DC 13.2V

AC 120V

car battery cord

(supplied)

To Cigarette Lighter

Helpful Hints

Do not watch TV while driving.

Use only the supplied car battery cord. Using another cord could damage the TV/VCR.

Make sure the cigarette lighter jack is free of ashes and other debris.

Make sure you push the car battery cord’s plug com- pletely into the cigarette lighter.

Always unplug the car battery cord from the cigarette lighter before you unplug it from the TV/VCR.

You must disconnect the car battery cord from the TV/VCR before you can use standard electrical (AC) power.

If you use the TV/VCR with the vehicle’s engine off, recharge the vehicle’s battery every four hours. Unplug the car battery cord from the cigarette lighter when you finish using the TV/VCR.

When you use the TV/VCR with a car battery cord, noise may appear on the TV/VCR screen.

Do not use this TV/VCR in high temperature conditions.

Page 8
Image 8
Philips CCA092AT owner manual Hooking Up the TV/VCR cont’d, Mobile Connections, Car battery cord, To Cigarette Lighter