Rod Antenna supplied, Crooked Pin, Straight Pin | Philips CCB 092AT

Hooking Up the TV/VCR (cont’d) 7

C.

Hooking Up Your TV/VCR With an Indoor Antenna

To install a rod antenna (supplied), push the stem of the antenna into the antenna hole on the back of the TV/VCR. Connect the anten- na wire to the ANT(enna) Jack on the back of the TV/VCR as shown. Extend the antenna and adjust its length, direction, and angle for the clearest picture.

Rod Antenna (supplied)

DC 13.2V

AC 120V

ANT.

ANT

2

Connect the AC cord to the AC 120V jack on the back of the TV/VCR. Plug the AC cord into an AC power outlet.

3

Before you turn on the TV/VCR, go to page nine.

Helpful Hint

• Before connecting an antenna or cable signal to the ANT(enna) Jack, make sure the pin is not bent. If the pin is bent, straighten it as illustrated, then connect the antenna or cable signal to the ANT(enna) Jack.

Bent pin

Crooked Pin

Cable

Plug

Straight Pin

Image 7

Philips CCB 092AT owner manual Rod Antenna supplied, Crooked Pin, Straight Pin

Contents

CCB092AT For Customer Use Dear Philips product owner Declaration of Conformity FeaturesSafety Precautions Introduction Table of Contents Recording Prevention Putting Batteries in the Remote ControlUsing the Remote Control TV/VCR Maintenance Hooking Up the TV/VCR Hook up your TV/VCR using one of the connections shown Crooked Pin Rod Antenna suppliedStraight Pin Mobile Connections Hooking Up the TV/VCR cont’dCigarette Lighter Turning On the TV/VCR You cannot set up channels if you are using a Cable Box Press the Menu button Language Selection Automatic Channel Setup Press the PLAY/ o button or the STOP/ p button to select Adding/Deleting Channels Manual Clock Setting Setting the ClockCable Box users must set the clock manually Setting the Clock cont’d Automatic PBS Channel Selection Setting the Clock cont’d Wait for the TV/VCR to find the time Manual PBS Channel Selection Use the Number buttons to select your PBS station Press the PLAY/ button or the STOP/ button toSelect SET PBS CH. MANUAL. Then, press the F.FWD/B Button Daylight-Savings Time Time Zone Front Panel AC 120V Jack Rear PanelANTenna Jack DC 13.2V Jack Remote Control Buttons Remote Control Buttons cont’d Adjusting the Picture Controls Decrease Increase Adjusting the Picture Controls cont’dMore brilliant If you select Status ON, then select Counter only on If you select Status ON, then select Counter only OFFIf you select Status OFF Press the PLAY/ button or the STOP/ button to select Reminder VHS Quasi Play Back Sqpb Playing To stop recording, press the STOP/ button Tape Speeds Recording One-Touch Recording Different brands of equipment may operate differently Rerecording Tape Duplication Daily Timer Recording Time OFF To Correct Press Clear To END Press Exit Timer Recording cont’d Timer Recording cont’d With the TV/VCR on, press the Menu button Checking or Clearing Timer Recordings Defeat Recording Repeat Play Repeat Play Insert a tape in the TV/VCR Press the Menu button Press the STATUS/EXIT button to remove the menu. A-B B Repeat Play cont’d Press the STATUS/EXIT button. The real-time counter will Real-Time Counter Memory Viewing a Still Picture Playback OptionsForward and Reverse Searching SP/LP/SLP Super High Speed Searching LP/SLP Ground Blue Background Press the SLEEP/WAKE UP button Sleep Timer Wake Up Timer Volume Bar Automatic Operation Features Specifications Glossary Helpful Hints Helpful Hints cont’d TV/VCR Combination Limited Warranty 23-24 IndexPage Page Supplied Accessories