![](/images/new-backgrounds/1140699/14069957x1.webp)
1 Press MENU/OK.
2 Select [ANSW MACHINE] > [REMOTE
ACC.], then press MENU/OK to confirm.
3 Select [ON]/[OFF], then press MENU/OK to confirm.
»»The setting is saved.
Change the PIN code
1 Press MENU/OK.
2 Select [ANSW MACHINE] > [REMOTE
ACC.] > [CHANGE PIN], then press
MENU/OK to confirm.
3 Enter the old PIN, then press MENU/OK to confirm.
4 Enter the new PIN code, then press MENU/OK to confirm.
5 Enter the new PIN code again, then press MENU/OK to confirm.
»»The setting is saved.
Access the answering machine remotely
1 Make a call to your home number with a touch tone phone.
2 Enter # when you hear the announcement.
3 Enter your PIN code.
»»You now have access to your answering machine, and you can now listen to the new messages.
Note
•• You have 2 chances to enter the correct PIN code before your phone hangs up.
4 Press a key to carry out a function. See the Remote access commands table below for a list of available functions.
Note
•• When there is no message, the phone hangs up automatically if no key is pressed for 8 seconds.
Remote access commands
Key Function
1Repeat the current or listen to the previous message.
2Listen to messages.
3Skip to the next message.
6Delete the current message.
7Switch the answering machine on. (not available when you listen to the messages).
8Stop listening to the message.
9Switch the answering machine off. (not available when you listen to the messages).
Behavior of the LED display on the base station
The table below shows you the current status with different LED display behavior on the base station.
LED | Message status |
display |
|
Steady on | • There is no new message and |
| the memory is not full. |
| • The handset is switched on. |
| • Enter the paging mode |
Flashing | • There is a new message and the |
| memory is not full. |
| • There is an incoming call. |
| • Recording an incoming mes- |
| sage/announcement. |
| • Message playback. |
| • Remote access/listen to mes- |
| sages from the handset. |
Flashing | • There is no new message and |
(Fast) | the memory is full. |
| • Enter the registration mode |
28EN