Philips CDR771 Autostart recording, Preparing for autostart recording, Start autostart recording

English

RECORDING

Autostart recording

OPEN // CLOSE

PLAY // PAUSE

STOP

REC

RECORD

STORE/TORE/

TYPE

FINALIZE

ERASE

SOURCE

EASYEASY JOGJOG

CANCEL/

MENUMENU

DELETE

DISPLAY

AUDIO CD

RECORDABLE/REWRITABLE

Recordable

ENTER

PHONES

INFRA RED

ON / OFF

This feature enables you to make fast and easy recordings of a CD. Track increments are automatically detected from the source material. Track increments cannot be added manually. In analog source material a silence of 2.7 seconds or more is automatically detected as a track increment.

Important:

-Recording from CD-changers should always be started in the RECORD DISC, RECORD TRACK or MAKE CD mode.

Preparing for autostart recording

1 Make sure the disc is absolutely free of scratches and dust particles.

2 Press SOURCE repeatedly until (depending on the connection used):

➜DIGITAL I, OPTICAL I or ANALOG lights up and DIGITAL 1, OPTICAL or ANALOG appears on the display.

	REM	TIME TRACK		TOTAL REM TRACK TIME		STEP
SYNC MANUAL				RECORD	PROG
DIGITAL I			CD		SHUFFLE ALL
OPTICAL I			RW		REPEAT
ANALOG					SCAN TRACK

3 With the CD recorder stopped, press REC TYPE once: to select ‘RECORD DISC’;

twice: to select ‘RECORD TRACK’;

four times: to select ‘MAKE CD’. (Active for digital recordings.)

➜d and SYNC start to flash and the display shows the selection.

	REM	TIME TRACK		TOTAL REM TRACK TIME		STEP
SYNC MANUAL				RECORD	PROG
DIGITAL I			CD		SHUFFLE ALL
OPTICAL I			RW		REPEAT
ANALOG					SCAN TRACK

•If input label (DIGITAL I) flashes, the digital connection is incorrect.

Start autostart recording

1 To start recording, press PLAY on the selected source.

➜The CD recorder automatically starts to record and d lights continuously.

•If, however, you start the source during a track, recording starts at the beginning of the next track or after 2.7 seconds of silence in analog recordings.

•To check the elapsed recording time, press DISPLAY. (This can also be done during recording)

•The EASY JOG/ENTER key can be used to adjust the recording level.

•The recorder stops automatically.

2 To stop recording manually, press STOP on the CD recorder.

➜UPDATE lights up and SYNC and d go out.

•If STOP 9 was pressed within 3 seconds after pressing PLAY, no recording will take place.

•To interrupt recording, press PAUSE on the CD recorder.

➜d starts to flash. (Autostart recording is disabled.) To resume, press RECORD on the CD recorder.

After recording the display will show UPDATE for several seconds.

Note:

-Recordings from DAT, DCC or analog sources will only stop after 20 seconds silence.

-Auto track is always active.

Important:

If you want to play the recorded CDR disc on any regular CD player, it must first be finalized. See finalizing discs.

Finalized CDRW discs play only on CDRW compatible CD players.

16