The type plate is located on the rear of the set.
1Check whether the mains voltage as shown on the type
plate corresponds to your local mains voltage. If it does not,
consult your dealer or service organisation.
2 Make sure all connections have been made before
switching on the mains supply.
3Connect the mains cable supplied to AC MAINS ~ and to
the wall socket. This switches on the mains supply.
4Press ON/OFF to switch on the set.
➜ PHILIPS CD RECORDER will be displayed.
•Press ON/OFF again to switch off the set.
•Press yon the remote control to switch the set to Standby
mode.
When the set is switched to standby, it is still consuming
some power. To disconnect the set from the mains completely,
remove the mains plug from the wall socket.
For users in the U.K.: please follow the instructions on
page 3.
– Place the set on a solid, vibration free surface.
– Make sure there is sufficient space around the set to
prevent overheating.
– Do not place the set near a source of heat or in direct
sunlight.
– Do not use the set under extremely damp conditions.
– If the set is placed in a cabinet, make sure that a 2.5 cm
space remains free on all sides of the CD recorder for
proper ventilation.
– Active mobile phones near to the set may cause
malfunctions.
1Open the battery compartment cover.
2Insert 2 batteries (AA, LR6 or UM-3; as supplied) as shown.
3Replace the cover.
Note: We recommend you use 2 batteries of the same type
and condition.
Batteries contain chemical substances, so they should
be disposed of properly.
2x AA, LR6, UM-3 / 1,5 V
Inserting batteries in the remote control
Setup recommendations
AC MAINS
Power supply/Mains
INSTALLATION
14
English
xp CDR785/00 engels.4 14-11-2000 16:30 Pagina 14