xp CDR785/00 engels.4
TROUBLESHOOTING
WARNING
Under no circumstances should you try to repair the set yourself as this will invalidate the guarantee. Do not open the set as there is a risk of electric shock. If a fault occurs, first check the points listed, before taking the set for repair.
If you are unable to solve a problem by following these hints, consult your dealer or service centre.
LASER SAFETY
This unit employs a laser. Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury.
English
SYMPTOM
• possible solution:
No power
•ensure that the ON/OFF button is on: the set is in standby mode, press any key to activate it
•ensure that the mains cable is plugged in correctly
•switch the set OFF and then immediately back ON
Auto track does not work
•check if auto track is selected
•check if there are 2.7 seconds silence in between the tracks (analog recording only)
•check if the source is a consumer source with the digital output according to the IEC audio standard
•source is DVD player (no track information)
No sound
•check the audio connections
•if using an amplifier, try using a different source
Amplifier sound is distorted
•check that the analog output of the set is not connected to the amplifier Phono input
Play will not start
•ensure that the label of the CD is facing up
•clean the disc
•check that the disc is not defective by trying another disc
Remote control does not work
•point the remote control directly at the set
•check the batteries and replace if necessary
•select the right source first
DISC RECOVER indication
•a power failure has occurred during recording, the CD recorder is attempting to repair the disc
•if DISC ERROR then appears on the display, the disc cannot be recorded further, and cannot be finalised. But it can still be played on the CD recorder or another CD recorder.
•on a CDRW disc, the track being recorded is lost, but further recording and finalization can still be done
INSERT DISC indication
•replace or clean the disc
•insert a CD(RW), label upwards
•wait until the lens has cleared
USE AUDIO CD indication
•insert a digital audio disc marked with “Digital audio” and the special logo
CHECK INPUT indication
•select the correct input
•make sure the connection cable is properly connected
Will not record
•clean the disc
•check if CDR(W) is an unfinalized disc
•check that the disc is recordable and replace if necessary
•the disc is not an AUDIO disc (WRONG DISC)
•wrong input source chosen. Input label flashing (CHECK INPUT)
•text memory full (MEMORY FULL / FINALIZE CD). When a CDRW has to be unfinalised for recording. Erase text for other disc(s) or finalize other disc(s) to obtain memory space
Recording is distorted
• make sure the recording level is correct
20 second pause between recordings
• see “Recording with automatic synchronized start“.
Set does not react
• switch the set OFF and then immediately back ON
Recorded disc does not play in other standard CD player
•finalize the CDR(W)
•insert the CDRW in a CDRW compatible player
33