English
INSTALLATION
Power supply | Inserting batteries in the remote control |
1 Plug the power cord supplied into the MAINS connector on the CD recorder, then into a mains socket.
2 Press POWER ON/OFF.
➜The recorder is now in Standby mode (Red led on). It takes approximately 2 seconds for the led to light up after pressing POWER ON/OFF.
Note:
-If the CD recorder is in Standby mode (red led on), press any key to activate the recorder.
-The CD recorder will automatically adjust to the local mains voltage.
-When the CD recorder is in the ‘OFF’ position, it is still consuming some power. If you wish to disconnect your player completely from the mains, withdraw the plug from the AC outlet.
Setup recommendations
-Place the CD recorder on a solid, vibration free surface.
-Do not place the CD recorder near a source of heat or in direct sunlight.
-Do not use the CD recorder under extremely damp conditions.
-If the CD recorder is placed in a cabinet, make sure that a 2.5 cm space remains free on all sides of the CD
recorder/player for proper ventilation.
Important:
-Do not put the CD recorder on top of other equipment that heats up the CD recorder (e.g. receiver or amplifier).
1 Open the battery compartment cover.
2 Insert 2 batteries (“AA”,
3 Replace the cover.
Note: We recommend you use 2 batteries of the same type and condition.
Batteries contain chemical substances, so they should be disposed of properly.
16
