Philips CGA7740N manual Your non-WPSdevice is installed on your network, via the PBC method

3.4.2 via the PBC method

1Check that your Wireless router and that the other WPS device are connected and ON

2Push and hold the WPS button, located on the front side on your router, for 3 seconds

3Push and hold the WPS button of the other WPS device for 3 seconds (refer to the manual of the other WPS device for location)

• The other WPS device is installed on your network

OR

1Check that your Wireless router and that the other WPS device are connected and ON

2On your Internet Browser, enter http://192.168.2.1 in the address field and click on GO to access the webpages

3Click on the WIRELESS tab on the left side of the page and select PBC to open the corresponding subpage

4Click on START PBC

• The other WPS device is installed on your network

Note

The push and hold procedure on the two WPS buttons (router and other WPS device) has to be done within a two minutes’ interval.

3.4.3 via the Manual configuration

This method enables you to configure client devices without WPS function.

1On your Internet Browser, enter http://192.168.2.1 in the address field and click on GO to access the webpages

2Click on the WIRELESS tab on the left side of the page and select Manual to open the corresponding subpage

3Take note of the settings displayed and configure your non-WPS device accordingly

• Your non-WPS device is installed on your network

Getting started 7