Playing a CD
1Press 2(PLAY) to start playback. ™ The disc tray, track number and
elapsed playing time of the current track appear on the display.
•To interrupt playback, pressÅ.
™The playing time flashes.
•To resume playback, pressÉagain.
2 To stop playback, press Ç.
Notes:
–All the available discs will play once, then stop.
–When the CD has stopped playing, the system will switch to standby mode after 30 minutes if no button is pressed.
Disc Change
You can change the outer two discs while the third inner disc is stopped or is playing.
1Press DISC CHANGE.
™ The CD carousel tray slides out.
2Replace the discs in the left and right
disc trays.
•If you wish to change the inner disc during playback, press DISC CHANGE again.
™"DISC CHANGE" will be displayed.
™The CD will stop playing.
™The CD carousel tray will close to retrieve the inner CD then open again
with the inner CD accessible.
3Press OPEN•CLOSE to close the CD carousel tray.
Selecting a desired track
Selecting a desired track when playback is stopped
1Press íor ë(or Digit
2Press 2(PLAY) to start playback.
™The selected track number and elapsed playing time appear on the display.
Selecting a desired track during playback
•Press íor ë(or Digit
™The selected track number and elapsed playing time appear on the display.
•If you press íonce it will skip to the beginning of the current track and play the track again.
Note:
–Pressingíduring shuffling can only skip to the beginning of the current track.
Searching for a particular passage during playback
•Press and hold àor áuntil the desired passage is located.
™ The volume will be reduced.
•Play returns to normal when àor á is released.
Programming Tracks
Programming tracks of a loaded CD is possible when playback is stopped. The display will indicate the total tracks stored in the programme. Up to 40 tracks can be stored in the memory in any order. When 40 tracks are stored and you attempt to store another track, the display will show "PROGRAM FULL".
1Load the desired discs in the disc trays.
2Press PROG to start programming. ™ The PROG starts flashing.
3Press the CD (CD 1•2•3) or CD 1/2/3 button to select the disc.
4Press íor ë(or Digit
5Press PROG to store the track.
•Repeat steps 3 to 5 to store other discs and tracks.
6Press Çonce to end programming.
™The total number of tracks programmed and total playing time appear on the display.
CD |
| |
Notes: | English | |
– If the total playing time is more than | ||
| ||
"99:59" or if one of the programmed |
| |
tracks has a number greater than 30, |
| |
then |
| |
instead of the total playing time. |
| |
– If the system is reading the disc, |
| |
programming is not possible, |
| |
"READING" will be displayed and |
| |
followed by "DISC X" "X" is the |
| |
current read disc number. |
| |
– During programming, if no button is |
| |
pressed within 20 seconds, the system |
| |
will exit programme mode |
| |
automatically. |
|
Reviewing the program
Reviewing of the programme is possible only when playback is stopped.
1Press íor ërepeatedly to review the programmed tracks.
2Press Çonce to exit review mode.
33
1pg | 33 |
9/14/00, 8:37 AM