1Press SETUP.
» [General Setup] menu is displayed.
2Select [OSD Language], and then press 
.
3Press 
to select a language, and then press OK.
Turn on progressive scan
Note
•To use the progressive scan feature, you must connect a progressive scan TV with the component video jacks (see “Connect” > “Connect audio/video cables” > “Option 2: Connect to the component video jacks” for details).
|
| Note |
|
|
|
| |
|
|
| English |
• | If a blank/distorted screen is displayed, wait for 15 | ||
| seconds for the auto recovery. |
| |
• If no picture is displayed, turn off the progressive scan |
| ||
| mode as follows: |
| |
1) Press 
to open the disc compartment.
2)Press the Numeric button ‘1’.
6Press SETUP to exit the menu.
7You can now turn on the progressive scan mode on the TV (see the TV user manual).
Note
•During play, when the progressive scan mode is on for both this product and the TV, distorted picture may display. In this case, turn off the progressive scan feature on both this product and the TV.
Use Philips EasyLink
This product supports Philips EasyLink which uses the HDMI CEC (Consumer Electronics Control) protocol. You can use one single remote control to control
Note
•To enable the EasyLink feature, you must turn on the HDMI CEC operations on the TV and on other devices connected to TV. Refer to the TVs/devices manual for details.
1Turn on the TV to the correct viewing channel for this product.
2Press SETUP.
3Press 
to select [Video Setup].
4Select [Progressive] > [On], and then press
OK.
» A warning message is displayed.
5To proceed, select [Ok] and then press OK. » The progressive setup is complete.
One-touch play
1Press 
to turn on this product.
»TheTV (if supports
»If a disc is loaded in this product, disc play automatically starts.
One-touch standby
1Press and hold 
on the remote control for more than 3 seconds.
»All the connected devices (if the device supports
EN 9
