Select menu display language
Note
If this product is connected to a HDMI CEC compliant TV, skip this setting. It switches automatically to the same OSD menu language as per your TV setting (if the language set on TV is supported by this product).
The language options may vary from different regions.
1Press SETUP.
» [General Setup] menu is displayed.
2Select [OSD language], then press
.
3Press 
to select a language, then press OK.
Turn on progressive scan
Note
To use the progressive scan feature, you must connect a progressive scan TV with the component video jacks (see “Connect” > “Connect video cables” > “Option 2: Connect to the component video jacks” for details).
3Press 
to select [Video Setup].
4Select [Progressive] > [On], then press OK. » A warning message is displayed.
5To proceed, select [Ok] and press OK. » The progressive setup is complete.
Note
If a blank/distorted screen is displayed, wait for 15 | English |
seconds for the auto recovery. | |
If no picture is displayed, turn off the progressive scan |
|
mode as follows: |
|
1) Press to open the disc compartment. |
|
2) Press the Numeric button ‘1’. |
|
6Press SETUP to exit the menu.
7You can now turn on the progressive scan mode on the TV (see the TV user manual).
Note
During play, when the progressive scan mode is on for both this product and the TV, distorted picture may display. In this case, turn off the progressive scan feature on both this product and the TV.
Use Philips EasyLink
This product supports Philips EasyLink which uses the HDMI CEC (Consumer Electronics Control) protocol. You can use one single remote control to control
Note
To enable the EasyLink feature, you must turn on the HDMI CEC operations on the TV and on other devices connected to TV. Refer to the TVs/devices manual for details.
One-touch play
1 Press the STANDBY
button to turn on this product.
» TheTV (if supports
» If a disc is loaded in this product, disc play automatically starts.
1Turn on the TV to the correct viewing channel for this product.
2Press SETUP.
EN 25
