Lexicon RV Receiver manual Setup

Setup Lexicon

The microphone should be held within two feet of the speaker baffle as a test tone is sent to the speaker.

The Subwoofer test is done in two parts. The user is instructed to hold the microphone to the left of the primary listening position and then to the right of the primary listening position. Two test tones are sent out to all connected subwoofers during each of the two test phases. Two tones are sent to ensure that subwoofers with auto power settings are active during the procedure.

Note: If there are no subwoofers in the system, then this test will not pass and must be skipped.

For optimum results, all noise generators in the room should be removed before performing the full or semi autocal procedure. However, air conditioners and similar steady-state background noise should have minimum impact on the test and can be left on.

When the procedure is complete, the user will be prompted to save the settings. These settings can be saved in one of three Preset locations. See Section 4: Audio Controls & Video Status for more information on the Preset locations.

Note: When calibration is complete, the volume level is set to a relatively high level. Before playing an audio track, be sure to turn the volume down to avoid potentially offensive or damaging volume levels.

3-8