Lexicon RV Receiver manual Cloning other Lexicon RV-5 Remote Controls

RV-5 Appendix C

switch components without triggering the macro. Only holding down the component button will trigger the macro.

To set the “Press & Hold” macro, enter a delay as the first step of the macro by pressing the PAUSE () button. Each press adds half a second to the delay. The amount of delay determines how long the user must hold down the button before the macro is sent.

Cloning other Lexicon RV-5 Remote Controls:

If you happen to own more than one RV-5 remote control, you can copy and transfer the setup from one remote to the other. Follow the instructions below to clone your RV-5 remote control.

1.On both the programmed remote control and the remote that you want to program, press and hold the MAIN and ENT (Enter) buttons at the same time. After about 3 seconds, “SETUP” is displayed in the Menu name area at the top of the LCD touch screen. This is the Setup mode of the remote control.

NOTE: You now have 30 seconds to perform the next step while the remote is in the Setup mode. If a button is not pressed within 30 seconds, the SETUP menu name will revert to MAIN, indicating that the remote control is no longer in Setup mode. If this occurs, you will need to repeat this step to re-enter the Setup mode.

2.Touch the CLONE button on both remotes. The menu name changes to “CLONE” and the bottom of the screen flashes “SELECT BUTTON”. A new screen now displays with the options: SEND, RECV, and EXIT.

Touching the EXIT option will leave the menu without making any changes or triggering the cloning process.

3.Line up the “master” remote control with the “slave” remote control, head-to-head, one or two inches apart.

4.On the “slave” remote, touch the RECV option. The SEND/RECV options are replaced with “START” and the bottom of the touch screen flashes “PRESS START”.

5.On the “master” remote, touch the SEND option. The SEND/RECV options are replaced with “START” and the bottom of the touch screen flashes “PRESS START”.

6.First on the “slave” remote and then on the “master” remote, touch the START option to begin the cloning process.

Note: Cloning typically takes about 40 seconds. After a successful cloning is complete, the newly cloned remote will flash “GOOD”.

7.When finished, exit the Setup mode by pressing the MAIN button until the touch screen displays MAIN in the menu heading area. The remote control is in normal operation mode again.

Setting System Volume Control & Other Punch Throughs:

The RV-5 remote control provides the option of setting up the volume control over all of the components in your home theater system, even with components that don’t have their own built-in volume controls, such as TiVo. This is a very powerful feature as, once it’s setup, it will save you the constant hassle and inconvenience of switching between component modes to individually adjust volume controls. This feature is called a “Punch Through” and is not limited to strictly volume control. Follow the instructions to set the system volume control. Then see the note following the instructions to learn what other punch through features are available.

1.Since a home theater system may use the RV-5 for its sound source, first you must identify which component you want to use for the system sound/volume control.

2.On the remote control, press and hold the MAIN and ENT (Enter) buttons at the same time. After about 3 seconds, “SETUP” is displayed in the Menu name area at the top of the LCD touch screen. This is the Setup mode of the remote control.

NOTE: You now have 30 seconds to perform the next step while the remote is in the Setup mode. If a button is not pressed within 30 seconds, the SETUP menu name will revert to MAIN, indicating that

C-11