Setup

Lexicon

DEFAULT SUR

 

 

STANDARD, USE LAST

 

 

 

 

 

 

SETUP

 

INPUT SETUP

 

DEFAULT SUR

 

Identifies the Default Surround Mode that is activated when a digital source is selected. The STANDARD parameter activates the “standard” decoder of the source input. The USE LAST selection allows the RV-5 software to “remember” the last used listening mode for any given input source. Once selected, that mode will always be active on the corresponding input until another listening mode is selected. This parameter affects all inputs.

Note: If the LOGIC 7 DEFAULT parameter in the SURROUND CONFIG menu is set to ON, the USE LAST selection is defeated and the listening mode will always switch to a LOGIC 7 mode. For normal functionality with the USE LAST selection, make sure that the LOGIC 7 DEFAULT parameter is set to OFF.

A/D SAMPLE RATE

 

 

48 KHZ, 96 KHZ

 

 

 

 

 

 

SETUP

 

INPUT SETUP

 

A/D SAMPLE RATE

 

The RV-5 converts the incoming analog audio signals to digital audio for all audio processing. The A/D SAMPLE RATE parameter allows you to select the sample rate of the A/D converters. Some surround processing modes, such as those in the DSP Mode Family, are only available at the 48 kHz sampling rate. This setting is only available for incoming analog audio streams and does not apply to any of the ANALOG BYPASS modes.

A/V SYNC DELAY

 

 

0 TO 180 mS

 

 

 

 

 

 

SETUP

 

INPUT SETUP

 

A/V SYNC DELAY

 

Delays the audio until it matches the on-screen video. Select a value to activate an audio signal delay to compensate for video that is delayed relative to the audio. The A/V sync delay range is 0 to 180 ms in 1 ms increments. Each input has an independent A/V Sync Delay parameter.

ADVANCED VIDEO

SETUP

 

INPUT SETUP

 

ADVANCED VIDEO

Selects the ADVANCED VIDEO menu, which provides fine-tuning adjustments to the video output. For more information, refer to the next section, “Advanced Video”.

Note: Most of the Advanced Video parameters are only available when the V-Process parameter is set to FAROUDJA.

TRIGGER 2

 

 

OFF, ON

 

 

 

 

 

 

SETUP

 

INPUT SETUP

 

TRIGGER 2

 

Selects the TRIGGER 2 parameter, which configures the Trigger OUT 2 connector on the rear panel. This trigger output can be configured independently for each input so that a trigger voltage signal is sent to the Trigger Out 2 connector when a specific input is selected. If the Trigger 2 parameter is set to ON, it will output its voltage when the associated input is activated in the Main Zone. It is not activated by Zone 2 input switching. The default for the Trigger 2 parameter is OFF.

ZONE-2 OUT

 

 

ANALOG, DOWN MIX

 

 

 

 

 

 

SETUP

 

INPUT SETUP

 

ZONE-2 OUT

 

Identifies the type of audio that is sent to the Zone 2 outputs. The ANALOG setting is a straight bypass of the Main Zone stereo analog audio to the Zone 2 outputs. DOWN MIX provides a stereo DOWN MIX of the incoming audio to the Zone 2 outputs. DOWN MIX, which should be selected for digital or multi-channel analog sources, is only available if the Main Zone has an input selected that will accept a down mixed source. The ZONE 2 OUT parameter is NOT input-specific; a selection made for one input will be reflected in ALL inputs.

3-18

Page 44
Image 44
Lexicon RV Receiver manual Default SUR, Sync Delay, Advanced Video, Trigger, ZONE-2 OUT