Lexicon RV Receiver manual Change Monitor Message, FAR Field Error, Autocal Error Messages

Troubleshooting & Maintenance Lexicon

CHANGE MONITOR

MESSAGE

This error message flashes on the 2 -line OSD and front panel displays when an analog signal is being sent to an HDMI monitor.

CHANGE MONITOR TO ANALOG IN

FAR FIELD ERROR

This error message will display when the microphone does not detect sound from a speaker that has a cross-over setting other than “NONE” during the Far Field Test.

FAR FIELD ERROR

Speakers detected:

FRT-L: NO	SIDE-R: NO
CENTER: YES	REAR-R: YES
FRT-R: YES	REAR-L: YES
	SIDE-L: YES

Verify mic position

To correct the problem, change the video monitor setting to an analog input source.

AUTOCAL ERROR MESSAGES

To correct the problem, check the microphone position, verify the speaker cables are connected properly, verify that the volume level is correct, and repeat the test.

and spkr connections. If OK, raise volume 5dB.

REPEAT TEST

BACK TO SPK/EQ SETUP

The following error messages apply specifically to error conditions that exist during the AUTOCAL or SEMI AUTOCAL procedures, or that pertain to the saved AUTOCAL settings.

NEAR FIELD ERROR

MICROPHONE OVERLOAD ERROR

This error message will display when the microphone is placed too close to the speaker grille of the speaker under test during the Far Field, Near Field, or Subwoofer Tests.

CAUTION!

MICROPHONE OVERLOAD

Verify microphone position and lower volume 6dB.

REPEAT TEST

BACK TO SPK/EQ SETUP

This error message will display when the Near Field test has failed. Typically, this failure occurs because the microphone is not in the proper position or the volume setting is too low.

To correct the problem, verify that the microphone is within two feet of the speaker under test, verify the speaker cables are connected properly, verify that the volume

NEAR FIELD AUTOCAL ERROR

Verify mic position and spkr connections. If OK, raise volume 5dB.

REPEAT TEST

BACK TO SPK/EQ SETUP

If the microphone is too close to the speaker during testing, damage to the speaker or microphone may result.

To correct the problem, move the microphone further away from the speaker under test and repeat the test.

level is correct, and repeat the test.

6-8