Lexicon RV Receiver manual Appendix C

RV-5 Appendix C

1.Line up the RV-5 remote control with the other remote control, head-to-head, one or two inches apart.

2.On the RV-5 remote control, press and hold the MAIN and ENT (Enter) buttons at the same time. After about 3 seconds, “SETUP” is displayed in the Menu name area at the top of the LCD touch screen. This is the Setup mode of the remote control.

NOTE: You now have 30 seconds to perform the next step while the remote is in the Setup mode. If a button is not pressed within 30 seconds, the SETUP menu name will revert to MAIN, indicating that the remote control is no longer in Setup mode. If this occurs, you will need to repeat this step to re-enter the Setup mode.

3.Touch the LEARN option to select the Button Learning Method. The menu name changes to “LEARN” and the menu options area now contains seven component options. The bottom of the screen flashes “SELECT”.

4.Select the component that you want to program. If the component you wish to setup is not on this page, touch the menu

page arrow to select from the components on page 2.

Once a selection is made, the menu name changes to the selected component name.

If you want to teach any command to a component button on the RV-5 remote control, press the component button when the menu name says “LEARN”. The menu name will change to “READY” and the menu page area indicates the button that you pressed. If you pressed the wrong button, press the MAIN button to return to the Setup menu where you can start again (return to Step 3). Once “READY” is displayed, skip ahead to Step 6.

5.Select the component option that you want to teach the command to - everything except for the MAIN button and the

menu page arrows can be taught. The menu name will change to “READY” and the menu page area indicates the button that you pressed.

6.Press and hold the button on the other remote control that you want to teach to the RV-5 remote. When the menu name on the touch screen of the RV-5 remote control changes to “GOOD” or “FAILD”, release the button.

If “GOOD” is displayed, the bottom of the screen flashes “SAVED”. The learning procedure is complete and was successful.

If “FAILD” is displayed, try teaching the same button once again by repeating Steps 5 & 6.

7.Repeat Steps 4 through 6 to teach the RV-5 remote control any additional button commands from the component’s remote. To return to Step 4, press the MAIN button once.

8.When you are done teaching the Lexicon remote control, exit the Setup mode by pressing the MAIN button until the touch screen displays MAIN in the menu heading area. The remote control is in normal operation mode again.

Test all your new commands. If any of them don’t work, try the button learning procedure again, keeping in mind the following suggestions:

•Move to another room. Plasma TVs, sunlight, halogen, or quartz lighting can interfere with the learning process.

•Even though the old remote seems to be working fine, replace the current batteries with fresh alkaline batteries.

•Gradually vary the distance between the remote controls. Try 1-inch, 2-inches, and so on up to 4-feet.

•Try tapping the button on your old remote instead of just pressing and holding it during the learning process.

The following list provides additional information regarding the button learning procedure and how the RV-5 remote control behaves when taught.

C-5