RV-5

Setup

DISPLAY SETUP

Selecting the SETUP menu DISPLAY SETUP option opens the DISPLAY SETUP menu, which is used to customize the OSD and front panel display, and setup other display-related features.

MAIN MENU

AUDIO CONTROLS VIDEO CONTROLS

SETUP

SETUP

DISPLAY SETUP

SPEAKER/EQ SETUP INPUT SETUP SURROUND CONFIG DOLBY CONFIG MUTE LEVELS POWER ON SETTINGS

DISPLAY SETUP

CONNECTION: HDMI/DVI

HDMI AUDIO OUT: NO ON-SCREEN DISPLAY FRONT PANEL DISPLAY

ON-SCREEN DISPLAY

2-LINE OSD: 3s

MENU TIME OUT: 30s

FRONT PANEL DISPLAY BRIGHTNESS: FULL TIME OUT: NONE

CONNECTION

ANALOG, HDMI/DVI

SETUP DISPLAY SETUP CONNECTION

Selects the CONNECTION parameter, which identifies the active video output connectors on the RV-5 rear panel. The following list of conditions identify the behavior of this parameter.

If ANALOG is selected, only the analog video connectors are available and will output the video signal.

If HDMI/DVI is selected, both the analog and HDMI video connectors are available and will output the video signal.

If the video input is set to HDMI and the CONNECTION parameter is set to ANALOG, then no video is output.

If the HDMI video input is copy-protected (HDCP), no video is output on the analog output connectors. This is a requirement of HDCP and not a limitation of the RV-5 Receiver.

HDMI AUDIO OUT

YES, NO

SETUP DISPLAY SETUP HDMI AUDIO OUT

Selects the HDMI AUDIO OUT parameter, which identifies if audio is sent on the HDMI output. If the HDMI AUDIO OUT parameter is set to YES, then a two-channel DOWN MIX of the source audio is sent over the HDMI connection at the maximum bit rate of the display’s audio system. This audio stream is in addition to the normal audio outputs. If the parameter is set to NO, this audio is not sent.

2-LINE OSD

 

OFF, 3, 4, 5, 6 SECONDS

 

 

 

 

 

 

 

 

SETUP

 

DISPLAY SETUP

 

ON-SCREEN DISPLAY

 

2-LINE OSD

 

Selects the 2-LINE OSD parameter from the On-Screen Display (OSD) menu. The 2-Line OSD parameter identifies the length of time that the 2-line OSD is displayed and can be set to display from three to six seconds in one-second increments. If OFF is selected, then the 2-line OSD is not displayed.

Note: If OFF is selected, the menu screens are still displayed. This parameter only affects the 2-line OSD display, which is identical to the front panel 2-line display.

3-3

Page 29
Image 29
Lexicon RV Receiver manual Display Setup, Connection, Hdmi Audio OUT, Line OSD