Lexicon RV Receiver manual Subwoofer CAL Error, CROSS-OVER Change Warning

RV-5 Troubleshooting & Maintenance

SUBWOOFER CAL ERROR

This error message will display when the Subwoofer test has failed. Typically, this failure occurs because the microphone is not in the proper position or the volume setting is too low.

To correct the problem, check the microphone position, verify the subwoofer cables are connected properly, verify that the volume level is correct, and repeat the test.

SUBWOOFER CAL ERROR Subwoofers detected:

SUBWOOFER 1: NO

SUBWOOFER 2: NO Verify mic position and sub connections.

If OK, raise volume 5dB.

REPEAT TEST

BACK TO SPK/EQ SETUP

Note: If you are using a powered subwoofer, verify that it is powered on.

CROSS-OVER CHANGE WARNING

This warning message will display the first time each speaker or subwoofer cross-over is manually changed from the AUTOCAL or SEMI AUTOCAL settings.

Press the cursor button on the remote control to clear the warning message. When cross-over changes are complete, run the SEMI AUTOCAL procedure.

CAUTION

Changing these settings will affect the autocalibration.

Run SEMI AUTOCAL after changes are made.

RETURN TO MENU

6-9