Lexicon RV Receiver manual Installation Considerations, Remote Control Battery Installation

Getting Started Lexicon

INSTALLATION CONSIDERATIONS

The RV-5 requires special care during installation to ensure optimal performance. Pay particular attention to the instructions below and to other precautions that appear throughout this user guide.

DO install the RV-5 on a solid, flat, level surface such as a table or shelf.

DO select a dry, well-ventilated location out of direct sunlight.

DO NOT expose the RV-5 to high temperatures, humidity, steam, smoke, dampness or excessive dust. Avoid installing the RV-5 near radiators or stacking the RV-5 over other heat-producing equipment such as a power amplifier.

DO NOT place the RV-5 on a thick rug or carpet, or cover the RV-5 with a cloth, as this might prevent proper cooling.

DO NOT place the RV-5 on a windowsill or any location exposed to direct sunlight.

DO NOT obstruct the front panel IR receiver window. The remote control must be in line of sight with the IR receiver for proper operation (unless using the optional RF-1 Receiver).

DO NOT install the RV-5 on a surface that is unstable or unable to support all four feet.

CAUTION!

Before moving the RV-5, power the unit off using the rear panel power switch and unplug the power cord from the wall outlet.

REMOTE CONTROL BATTERY

INSTALLATION

The remote control requires four AAA batteries. The batteries should be replaced as needed. Alkaline batteries, which last longer without leaking, are recommended. When battery power is low, the remote control enters a low-voltage condition, preventing it from operating the RV-5. When this occurs, replace the batteries. Normal operation will resume when new batteries are installed.

Note: The Remote Control will not lose any custom settings if the batteries run out. All custom settings are stored in non-volatile FLASH memory.

To replace the remote control batteries:

1.Locate the battery compartment on the back of the remote control. Press the tab and lift the cover away from the remote control.

2.Remove old batteries, if applicable.

3.Observing the proper polarity, insert four AAA batteries.

4.Align the cover over the battery compartment and gently press down until it snaps back into place.

5.Properly dispose of the old batteries.

1-4