Appendix C | |
|
|
Back light Time Out:
The back light feature lights the touch screen area and illuminates the buttons whenever the LIGHT button is pressed. The amount of time the back light remains on before timing out can be adjusted to your preferences. Follow the instructions below to change the back light time out setting.
1.On the remote control, press and hold the MAIN and ENT (Enter) buttons at the same time. After about 3 seconds, “SETUP” is displayed in the Menu name area at the top of the LCD touch screen. This is the Setup mode of the remote control.
NOTE: You now have 30 seconds to perform the next step while the remote is in the Setup mode. If a button is not pressed within 30 seconds, the SETUP menu name will revert to MAIN, indicating that the remote control is no longer in Setup mode. If this occurs, you will need to repeat this step to
2. Touch the menu page arrow to access the second page of the SETUP menu.
3.Press the LIGHT button to customize the back light time out setting. A new screen now displays ON, 10, SAVE, and EXIT. The bottom of the touch screen says “SECOND” and there’s a flashing box over the “1” digit. The current setting for the back light time out is “10” seconds.
4.Use the number keypad to enter a new time. The setting range is 01 to 99 seconds. To turn the back light feature off, which saves battery life, touch the ON option. The ON button changes to OFF and the time is dashed out.
5.Touch the SAVE option to save the new setting. Touching the EXIT option will leave the menu without saving any changes.
6.When finished, exit the Setup mode by pressing the MAIN button until the touch screen displays MAIN in the menu heading area. The remote control is in normal operation mode again.
Adjusting the Touch Screen Contrast:
You can make the text in the touch screen area darker by pressing the MAIN and cursor buttons at the same time. To make the text appear lighter, press the MAIN and cursor buttons at the same time.
Customizing the Touch Screen:
The LCD touch screen component names and commands can be customized to your preferences. Follow the instructions below to change the text in a selected touch screen menu.
1.On the remote control, press and hold the MAIN and ENT (Enter) buttons at the same time. After about 3 seconds, “SETUP” is displayed in the Menu name area at the top of the LCD touch screen. This is the Setup mode of the remote control.
NOTE: You now have 30 seconds to perform the next step while the remote is in the Setup mode. If a button is not pressed within 30 seconds, the SETUP menu name will revert to MAIN, indicating that the remote control is no longer in Setup mode. If this occurs, you will need to repeat this step to
2.Touch the EDIT option to customize the touch screen option names. The menu name changes to “EDIT” and the bottom of the screen flashes “SELECT BUTTON”.
3.Touch the TEXT option. The menu name still reads “EDIT” but now the component options are displayed.
Once the TEXT option is pressed, the bottom of the screen flashes “SELECT”.
4.Navigate to the menu page where you want to EDIT the text. You can edit either the component names or the specific component controls. The menu name will reflect the actual menu heading, “EDIT” will no longer be displayed.
5.When the menu to be edited is displayed, touch the PAGE option until the desired screen is once again displayed.
