RV-5

Audio Controls & Video Status

To load a different saved EQ Preset into the system:

1.Decide which saved Preset location you want to load.

2.Select ACTIVE PS from the EQ PRESET menu.

3.

Use the

or cursors to select the Preset location you want

 

to load.

 

4.

Press the

cursor to save the selection.

When the Active PS is set to “USER”, this indicates a factory default condition.

Note: Once a Preset location has been selected and saved, the factory default “USER” option is no longer available for selection. Before a preset location is saved, toggling the EQ on & off results in a noticeable change in the subwoofer output level. This is normal behavior.

HF SHELF

 

 

 

+8dB to -8dB

AUDIO CONTROLS

 

EQ ADJUST

 

HF SHELF

 

Located in the EQ ADJUST menu, the HF SHELF control acts as a high-frequency shelf filter, which boosts or cuts frequencies above 1kHz. The HF SHELF parameter can be adjusted from +8dB to -8dB in 1dB increments.

Note: The HF SHELF parameter does not adjust the timbre of the rear speakers in the 7-CHANNEL listening mode.

TONE CONTROLS

OFF, ON

AUDIO CONTROLS TONE CONTROLS: OFF

Activates or deactivates the Bass and Treble Tone Controls. Bass and Treble controls are only active when the Tone Control parameter is set to ON.

Note: When the Tone Controls are OFF, the incoming audio datastream is stereo analog, and the Mode Family is set to STEREO, four different listening modes are available: 7CH STEREO, 5CH STEREO, 2CH STEREO, and 2CH BYPASS. Refer to the “Listening Modes” section of Section 3: Setup for more information.

BASS

+6dB to -6dB

AUDIO CONTROLS BASS

Controls the amount of low-frequency boost or cut applied to all of the audio outputs. Bass is an independent setting for each input, NOT a global setting. The BASS parameter can be adjusted from +6dB to -6dB in 1dB increments.

TREBLE

+6dB to -6dB

AUDIO CONTROLS TREBLE

Controls the amount of high-frequency boost or cut applied to all of the audio outputs except for the subwoofers. Treble is an independent setting for each input, NOT a global setting. The TREBLE parameter can be adjusted from +6dB to -6dB in 1dB increments.

4-3

Page 63
Image 63
Lexicon RV Receiver manual HF Shelf, Tone Controls, Bass, Treble, To load a different saved EQ Preset into the system