Lexicon RV Receiver Microphone Input Connector, CH Analog Audio Input Connectors, USB Connector

Basic Operation Lexicon

CAUTION!

Never make or break connections to the RV-5 unless the RV-5 and all associated components are powered off.

1 MICROPHONE INPUT CONNECTOR

Provides a microphone input for system calibration. The microphone input is only for use with the supplied microphone during the systemcalibration process. See Section 3: Setup for more information on system setup and calibration.

2 8-CH ANALOG AUDIO INPUT CONNECTORS

Provides 8-channel analog audio input via eight RCA connectors labeled Front L/R, Center, LFE, Side L/R and Rear L/R. These inputs are used to connect source devices such as high-resolution DVD players, DVD-Audio, or SACD players with discrete analog audio outputs. Depending on the source device in use, all eight connectors may be used, although only the Front L/R, Center, Side L/R, and LFE are required for 5.1 analog audio signals.

3 STEREO ANALOG AUDIO INPUT CONNECTORS

Provide stereo analog audio input. Six stereo analog audio input RCA connectors labeled 1 to 6 are available.

4 DIGITAL AUDIO INPUT CONNECTORS

Provide digital audio input via four S/PDIF optical (TOSLINK) and four S/PDIF coaxial (RCA) input connectors. Connectors are compatible with most PCM, Dolby Digital, and DTS(-ES) sources.

5 ZONE 2 AUDIO OUTPUT CONNECTORS

Provide preamplifier audio outputs for Zone 2.

6 USB CONNECTOR

Provides a USB port to connect to a PC computer, enabling the user to listen to audio from the computer through the RV-5 Receiver. The USB connector port is a “mini B” connector and requires a USB cable (not included). See Section 5: Tuner, PC, & Dock Controls for more information on the playback of computer audio.

7 TRIGGER OUTPUT CONNECTORS

Provide a 12V DC output to control connected components. Two trigger output connectors are available as 3.5 mm mono mini phone jacks. The OUT 1 connector is the power trigger and is not configurable; it is activated when the RV-5 is powered on or taken out of Standby, and deactivated when the RV-5 is powered off, either from the rear panel or by putting the RV-5 into Standby mode. The OUT 2 connector can be configured independently for each input, refer to Section 3: Setup for more information on how to configure the OUT 2 trigger.

Note: The OUT 2 trigger is referred to as “TRIGGER 2” in the Input Setup menu.

8 RS-232 CONNECTOR

The RS-232 serial connector provides serial remote control through a standard RS-232 connection. Refer to the Lexicon website (www.lexicon.com) for more details on controlling the RV-5 Receiver via the RS-232 connection.

2-6