44 | ST1000 Plus & ST2000 Plus Tiller Pilots - Owner’s Handbook | ||
|
|
|
|
| Dimension G | Pedestal socket length L | Part no. |
|
|
|
|
| 64 mm (2.5 in) | Standard dimension | - |
|
|
|
|
| 102 mm (4.0 in) | 38 mm (1.5 in) | D026 |
|
|
|
|
| 114 mm (4.5 in) | 50 mm (2.0 in) | D027 |
|
|
|
|
| 127 mm (5.0 in) | 64 mm (2.5 in) | D028 |
|
|
|
|
| 140 mm (5.5 in) | 76 mm (3.0 in) | D029 |
|
|
|
|
| 153 mm (6.0 in) | 89 mm (3.5 in) | D030 |
|
|
|
|
Mounting the pedestal socket
1.Mark the mounting ring’s position on the cockpit seat or counter.
2.Ensure that control dimensions A and B are correct.
3.Mark the bolt holes on the mounting ring and then drill three 6 mm (1/4 in) diameter holes.
4.Bed the mounting ring on a thin coat of silicon sealant.
5.Use three 6 mm (1/4 in) diameter bolts, nuts and washers to attach the mounting ring to the backing plate (with the backing plate on the other side of the mounting surface, as shown above).
6.Screw the mounting socket firmly into place.
Note: When the tiller pilot is not in use, you can unscrew the complete rod assembly to leave the cockpit unobstructed.
Alternative tiller pins
Your Raymarine dealer can also supply the following alternative lengths of tiller pin for other
|
| Description | Size | Part no. |
|
|
|
|
|
|
| Small threaded tiller pin | 25 mm (1.0 in) | D014 |
|
|
|
|
|
4 Installing the Tiller Pilot |
| Extra length tiller pin | 72 mm (2.8 in) | D020 |
|
|
|
| |
| Extra length threaded tiller pin | 72 mm (2.8 in) | D021 | |
|
|
|
| |
|
|
|
| |
|
|
|
|
|
