40 | ST1000 Plus & ST2000 Plus Tiller Pilots - Owner’s Handbook |
Tiller brackets
If the tiller is higher or lower than the mounting socket, you can use a Raymarine tiller bracket to vary the tiller pin offset so the pilot is horizontal.
Identifying the correct tiller bracket
1.Clamp the tiller on the boat’s center line.
2.Measure dimension D (if the pushrod is above the tiller) or dimension E (if the pushrod is below the tiller).
3.Select the appropriate bracket from the following table:
Dimension D | Dimension E | Bracket |
(pushrod below tiller) | (pushrod above tiller) | part no. |
|
|
|
25 mm (1 in) | 51 mm (2 in) | D009 |
|
|
|
51 mm (2 in) | 76 mm (3 in) | D010 |
|
|
|
76 mm (3 in) | 102 mm (4 in) | D011 |
|
|
|
102 mm (4 in) | 127 mm (5 in) | D159 |
|
|
|
127 mm (5 in) | 152 mm (6 in) | D160 |
|
|
|
D
4 Installing the Tiller Pilot
