42 | ST1000 Plus & ST2000 Plus Tiller Pilots - Owner’s Handbook |
3.Refer to the table to establish a cutting length for the cantilever rod – double check measurements before cutting.
4.Measure the rod from threaded end, then cut the cantilever rod to length L using a hacksaw. Remove any sharp edges with a file.
Dimension F | Cut length L |
654 mm (25.75 in) | 51 mm (2 in) |
|
|
705 mm (27.75 in) | 102 mm (4 in) |
|
|
743 mm (29.75 in) | 152 mm (6 in) |
|
|
806 mm (31.75 in) | 203 mm (8 in) |
|
|
832 mm (32.75 in) | 229 mm (9 in) |
|
|
4 Installing the Tiller Pilot
F
L
Mounting the cantilever assembly
To mount the cantilever assembly:
1.Temporarily assemble the cantilever by screwing the rod into the mounting ring.
2.Ensure the tiller pilot is horizontal and then mark the location of the mounting ring and its mounting holes.
3.Drill three 6 mm (1/4 in) diameter holes at the positions you have marked.
4.Bed the mounting ring on a thin coat of silicon sealant.
