Lexicon RV Receiver manual Manual Speaker Setup, Auto Settings

RV-5 Setup

MANUAL SPEAKER SETUP

Selecting the SETUP menu SPEAKER/EQ SETUP menu MANUAL option opens the MANUAL menu, which is used to manually set the speaker distances, cross-over points, and output levels.

SETUP

SPEAKER/EQ SETUP

MANUAL

SPEAKERS SPEAKER DISTANCES OUTPUT LEVELS

SPEAKER DISTANCES 1

AUTO SETTINGS: OFF

UNITS: FEET

FRONT LEFT: 0.0 ft

CENTER: 0.0 ft

FRONT RIGHT: 0.0 ft

SIDE RIGHT: 0.0 ft

REAR RIGHT: 0.0 ft

REAR LEFT: 0.0 ft

OUTPUT LEVELS 1

AUTO SETTINGS: OFF

INPUT: ALL

TEST TONE: AUTO

FRONT LEFT: 0dB

CENTER: 0dB

FRONT RIGHT: 0dB

SIDE RIGHT: 0dB

REAR RIGHT: 0dB

SPEAKER DISTANCES 2

SIDE LEFT: 0.0ft

SUBWOOFERS: 0.0 ft

OUTPUT LEVELS 2

REAR LEFT: 0dB

SIDE LEFT: 0dB

SUBWOOFER1: 0dB

SUBWOOFER2: 0dB

SPEAKERS

AUTO SETTINGS: OFF

FRONT L/R: 80Hz

CENTER: 80Hz

SIDE L/R: 80Hz

REAR/Z2 L/R: 80Hz

SUB/LFE LPF: 80Hz

SUBWOOFERS: 1

SUB HPF: 20Hz

SUB MODE: NORMAL

AUTO SETTINGS OFF, ON

SETUP SPEAKER/EQ SETUP MANUAL AUTO SETTINGS

Loads the values from the active preset into the speaker cross-over points, distances, or output level parameters. The Speakers (cross-over points), Speaker Distances, and Output Levels menus all have an Auto Settings parameter. All three are the same parameter, but each affects the individual sub-menus separately and independently of each other.

If the Auto Settings parameter is set to ON, the parameters in that menu cannot be manually changed until the Auto Settings parameter is set to OFF.

Note: Any manual settings will be lost if the active preset settings are loaded; if Auto Settings is set to ON in the Speakers, Speaker Distances, or Output Levels menus, then previous parameter values will be overwritten.

3-9