Lexicon RV Receiver manual Recalling Pre-Programmed Setup Code Numbers

Appendix C Lexicon

Note: The DOWN and UP buttons on the touch screen can be used to scroll the code number one digit at a time. If you hold your finger over the UP or DOWN button, the code number will scroll until your finger is removed.

8.When the component turns off, press the ON button on the remote to turn the component back on. Test several functions to ensure that the component responds correctly to the remote commands. If any of the buttons do not work properly, you may not have the right code - enter the next code option on your list until you find the best match for the component.

Note: If you are unable to find a code that will accurately control your component, then you’ll need to use the Button Learning procedure, which follows this procedure, to program the component.

9.Once you’ve found the right code, touch the SAVE option on the touch screen. The screen will blink “SAVED” two times, indicating that the code has been successfully saved.

10.Exit the Setup mode by pressing the MAIN button until the touch screen displays MAIN in the menu heading area. The remote control is in normal operation mode again.

11.Repeat Steps 1 through 10 to program all other components in your home theater system. For any components that do not have a valid 3-digit code, continue to the Button Learning procedure to program those components.

Recalling Pre-Programmed Setup Code Numbers:

In case you didn’t write down the pre-programmed code numbers that you used when you set up your Lexicon remote controls, these 3-digit manufacturers’ numbers can be recalled. Perform the following procedure to recall the pre-programmed 3-digit code for any component.

1.On the remote control, press and hold the MAIN and ENT (Enter) buttons at the same time. After about 3 seconds, “SETUP” is

displayed in the Menu name area at the top of the LCD touch screen. This is the Setup mode of the remote control.

NOTE: You now have 30 seconds to perform the next step while the remote is in the Setup mode. If a button is not pressed within 30 seconds, the SETUP menu name will revert to MAIN, indicating that the remote control is no longer in Setup mode. If this occurs, you will need to repeat this step to re-enter the Setup mode.

2.Touch the RECAL option. The touch screen now shows a four-page menu that lists each component name and the 3-digit code that was assigned to it.

3.Write down the code number for each component for future reference. Appendix D of this manual provides a convenient table for you to record the 3-digit pre-programmed code numbers.

4.Exit the Setup mode by pressing the MAIN button until the touch screen displays MAIN in the menu heading area. The remote control is in normal operation mode again.

Button Learning Procedure For Your Remote Control:

Follow the steps below to set up your RV-5 remote control using the Button Learning procedure. The RV-5 remote control can “learn” commands from other remote controls, both old and new, one button at a time. Follow the steps below to allow your RV-5 remote control to learn the button commands from other remote controls in your home theater system.

Note: We recommend that you use this procedure only after you’ve determined that no 3-digit manufacturers’ codes exist for the component in question.

C-4