Lexicon RV Receiver manual Routine Maintenance, Restoring Factory Default Settings

Troubleshooting & Maintenance Lexicon

ROUTINE MAINTENANCE

The bulleted items below describe routine maintenance that should be performed on a periodic basis.

•Clean the RV-5 exterior surface with a soft, lint-free cloth. Do not use alcohol, benzene, acetone-based cleaners or strong commercial cleaners. Do not use a cloth made with steel wool or metal polish. If the RV-5 is exposed to a dusty environment, a low-pressure blower can be used to remove dust from its exterior surface.

•Replace the remote control batteries as needed. The remote control requires four AAA batteries. When these batteries are low on power, the remote control enters a low-voltage condition that prevents it from operating the RV-5. Normal operation will resume when new batteries are installed.

Note: The Remote Control will not lose any custom settings if the bat- teries run out. All custom settings are stored in non-volatile FLASH memory.

RESTORING FACTORY DEFAULT SETTINGS

It is possible to reset the RV-5 Receiver to its factory settings. However, doing so will permanently delete any user-defined or manually-entered settings, including parameters such as speaker setup changes, input names, and tuner presets.

Before performing a factory reset, be sure to use the worksheets in Appendix D to record all of the input and setup information. The factory reset WILL delete all custom settings except for the saved EQ Presets.

To restore the factory default settings:

1.Record all parameters and user-defined settings on the Installation Worksheet that begins on page D-2.

2.Put the RV-5 into Standby.

3.Press and hold the MUTE and ST/MON buttons at the same time.

After several seconds, the RV-5 will turn on. The front panel display will state “RESET” and then it will return to the normal display. All parameters and user-defined values will now reflect the factory default settings, with the exception of any saved EQ Presets.

Note: If you want to save your settings before restoring the factory defaults, you must record them manually. The Installation Worksheet in Appendix D has been provided to assist you.

6-12