TUNER
20
You can search for radio stations by scanning the frequency
band. You can also key in the frequency of a known radio
station. If an FM station is being broadcast and received in
stereo, STEREO is shown.
Searching for radio stations
1Turn SOURCESELECTOR to select the tuner.
yTUNER is displayed.
2Select a waveband by pressing TUNER AM/FM repeatedly.
yThe selected waveband is displayed.
3Keep 1or 2pressed for approximately 1 second.
ySEARCH is displayed and the tuner tunes to a station
with sufficient strength.
4Repeat this procedure until you find the desired station.
•To fine tune to a weak transmitter, briefly press 1or 2as
often as necessary for optimum reception.
Tuning to a radio station by frequency (with the remote
control only)
1Press TUNER.
yTUNER is displayed.
2Press FR. D..
y_is displayed.
3Use 1–0 to key in the frequency of a radio station.
Note: Only valid numbers within the frequency range of the
tuner can be keyed in.
You can switch the tuner to a lower search sensitivity, to
search only for stations with a strong signal (FM only).
1Turn SOURCESELECTOR to select the tuner.
yTUNER is displayed.
2Press SENS. on the receiver.
yEither SENS HI or SENS LO is displayed for 5 seconds.
Note: While searching for radio stations, the actual sensitivity
is displayed. In this case, SENS LO means the tuner is
only looking for radio stations with a strong signal.
You may store up to 30 radio stations in the memory. The
receiver can select and program radio stations by itself or you
can choose them yourself.
Automatic programming
1Choose * TUNER from the menu and press NEXT 2.
2Choose AUTO INSTALL and press NEXT 2.
yThe preset number where programming will start, the
waveband and AUTO are displayed.
3Turn TUNERPRESET Xto change the preset number where
programming should start.
4Use TUNER AM/FM to switch to the desired waveband.
5Press ENTER / OK to start programming.
yAUTO INSTALL flashes and all available radio
stations are programmed, this may take a few minutes.
Programming is done when AUTO INSTALL stops
flashing.
Manual programming
1Choose * TUNER from the menu and press NEXT 2.
2Choose MAN INSTALL and press NEXT 2.
yA preset number, the waveband and the frequency are
displayed.
3Turn TUNERPRESET Xto change to the preset number
where the radio station should be stored.
4Tune to the desired radio station (see “Searching for radio
stations”).
5Press ENTER / OK to confirm your selection.
ySTORED is displayed briefly. The radio station is
programmed at the chosen preset number.
6Select and store all desired radio stations this way.
Storing radio stations
Switching FM sensitivity
Tuning to radio stations
English