Philips FW-C72 manual Easy Set, Switching the system ON, Switching the system to standby mode

Models: FW-C72

1 29
Download 29 pages 2.39 Kb
Page 13
Image 13
Easy Set

13

OPERATING THE SYSTEM

Even though the AC power cord is removed from and reconnected to the wall socket, the demonstration will remain off until it is switched on again.

To start the demonstration mode

Press and hold (on the system only) for five seconds when the system is in standby mode.

ª The demonstration will begin.

Easy Set

EASY SET allows you to store all available radio stations automatically.

Press and hold STANDBY ON (on the system only) for five seconds when the system is in standby or demonstration mode.

ªEASY SET” will be displayed, and followed by “TUNER” and then “AUTO”.

ªEASY SET will start searching for all radio stations on FM band and then followed by radio stations on AM band.

ªAll available radio stations with sufficient signal strength will be stored. Up to 40 presets may be stored.

Notes:

EASY SET will start with the FM band, if there are still presets available, the system will continue to store the AM band.

When EASY SET is used, all previously stored radio stations will be replaced.

The last preset radio station will appear on the display when EASY SET is completed.

Switching the system ON

Press CD, TUNER, TAPE or AUX.

You can also switch on the system by pressing any one of the CD DIRECT PLAY buttons.

Switching the system to standby mode

Press STANDBY ON or B on the remote control.

ªThe system will switch to standby mode.

ª(for model FW-C72 only) About five seconds later, the system will go into an energy saving mode if the demonstration mode has been disabled.

Selecting the Source

Press the respective source selection button: CD, TUNER, TAPE or AUX.

ªThe display indicates the selected source.

Note:

For an external source, make sure you have connected the audio left and right OUT terminals of the external equipment (TV,VCR, Laser Disc player, DVD player or CD Recorder) to the AUX/CDR IN terminals.

Selecting the Equalizer Display

You can select the desired equalizer display for the system.You must not press the DSC or INCREDIBLE SURROUND (for model FW-C71 only) button on the system before using the JOG control.

Adjust the JOG control to select the desired Equalizer Display, NORMAL, TOP DOWN, or NITE MODE.

ªThe selected display will be shown.

NORMAL Display

PROGRAM SHUFFLE

 

STEREO

REPEAT TIMER REC

 

BACK

NEWS T.A. AM MW FMLW

 

FRONT HSD

60Hz 250Hz 500Hz

1KHz

2KHz 4KHz 8KHz

TOP DOWN Display

PROGRAM SHUFFLE

 

STEREO

REPEAT TIMER REC

 

BACK

NEWS T.A. AM MW FMLW

 

FRONT HSD

60Hz 250Hz 500Hz

1KHz

2KHz 4KHz 8KHz

NITE MODE Display

PROGRAM SHUFFLE

 

STEREO

REPEAT TIMER REC

 

BACK

NEWS T.A. AM MW FMLW

 

FRONT HSD

60Hz 250Hz 500Hz

1KHz

2KHz 4KHz 8KHz

Note:

In NITE MODE, all lights will be switched off and the display brightness will be dimmed.

pg 01-27/C71-C72/37-Eng

13

12/16/99, 1:20 PM

3139 116 19521 (ENG)

Page 13
Image 13
Philips FW-C72 manual Easy Set, Switching the system ON, Switching the system to standby mode, Selecting the Source