24
English
3139 116 19782
CLOCK TIMER
View Clock
You can view the clock (if it is set) if the
system is in Standby mode or when any
sound source is selected (CD, TUNER, etc.).
The clock will be displayed for about 7
seconds.
•Press CLOCK/TIMER briefly.
™"PM 10:38 or 22:38" (the
current time) will be displayed
depending on whether you have
selected 12- or 24-hour mode.
™"--::
::
:--" will be displayed if the
clock is not set.
Note:
–When the system goes into low power
standby mode, the clock setting will not
be displayed.
Clock Setting
The clock can be set in either 12- or 24-
hour mode, e.g. "AM 12:00" or
"00:00". Before setting the clock, you
must be in the View Clock mode.
1Press CLOCK/TIMER to select clock
mode.
2Press PROG
(on the system only)
to
select 12- and 24- hour mode.
™If 12-hour mode is selected,
"AM 12:00" starts flashing.
™If 24-hour mode is selected,
"00:00" starts flashing.
3Set the hour withà or áon the
system.
4Set the minute withí or ëon the
system.
SHUFFLE
PROGRAM
FM
STEREO
BACK
HSD
REPEAT REC
LW
MW
AM
T.A.
NEWS
SOUND NAVIGATION
DIGITAL SOUND
CONTROL
DYNAMIC BASS
BOOST
TAPECD
PROG
CLOCK/
TIMER
DUB
(HSD)
REC
STANDBY
ON
SIDEA•BA.REV
TUNER AUX
PRESET▲
▲
STOP•CLEARSEARCH • TUNING PLAY PAUSE PREV NEXT
MINI HIFI SYSTEM
CD1 • 2 • 3 CDR / VIDEO
BAND TAPE 1 • 2
TIMER FRONT
60Hz 500Hz
250Hz 1KHz 2KHz4KHz 8KHz SS
LR
C
PRO LOGIC
SIDE
MIC
MIC
LEVEL
5Press CLOCK/TIMER again to store the
setting.
™The clock starts.
•To exit without storing the setting, press
Ç on the system
Notes:
–During clock setting, if no button is
pressed within 90 seconds, the system
will exit clock setting mode
automatically.
–When a power interruption occurs, the
clock setting is erased.
Timer Setting
•The system can switch on to CD,
TUNER, or TAPE 2 mode automatically
at a preset time. It can serve as an
alarm to wake you up.
•Before setting the timer, make sure the
clock is set correctly.
•The timer will always be switched on
once it is set.
•The volume of the timer will
increase from the minimum level
until the volume level before the set
is switched to standby mode.
1Press and hold CLOCK/TIMER for more
than
2 seconds
to select timer mode.
™“ AM 12:00” or “00:00" or the
last timer setting starts flashing
depending on whether you have
selected 12- or 24-hour mode.
™The TIMER starts flashing.
™The selected source is lit while other
available sources are flashing.
2Press CD, TUNER or TAPE to select the
desired source.
•Before selecting CD or TAPE, make sure
a CD or tape is loaded in the CD tray or
tape deck 2.
3Pressà or á on the system to set
the hour for the timer to start.
4Pressí or ë on the system to set the
minute for the timer to start.
Untitled-2 6/8/01, 10:13 AM24