Clock/Timer
2Press CD, TUNER or TAPE to select the desired source.
●Make sure the music source has been prepared. CD – Load the disc(s).To start from a specific track, make a program (refer to “CD Operation - Programming the disc tracks”).
TUNER – tune to the desired preset radio station.
TAPE – load the prerecorded tape into tape
deck 2.
3Press à or á on the system repeatedly to set the hour for the timer to start.
4Press í or ë on the system repeatedly to set the minute for the timer to start.
5Press CLOCK/TIMER to store the start time.
➜The timer is now set and activated.
➜TIMER will remain on the display.
●At the preset time, the selected source will be played.
To exit without storing the setting
●Press Çon the system.
Notes:
–If the selected source (CD or TAPE) is not available when preset timer is reached,TUNER will be selected automatically.
–During timer setting, if no button is pressed within 90 seconds, the system will exit timer setting mode automatically.
To deactivate the TIMER
●Press TIMER ON/OFF on the remote control. ➜ The display will show "CANCEL" and TIMER will disappear from the display.
To activate the TIMER
●Press TIMER ON/OFF on the remote control. ➜ The last timer setting will be shown for a few seconds and TIMER will appear on the display.
Sleep Timer Setting
The sleep timer enables the system to switch to Standby mode automatically at a preset time.
1Set the clock (refer to “Clock Setting”).
2Press SLEEP on the remote control repeatedly to select a preset time.
➜The selections are as follows (time in minutes):
60 ™ 45 ™ 30 ™ 15 ™ OFF ™ 60 …
➜"SLEEP XX" or "OFF" will be displayed. "XX" is the time in minutes.
3When you reach the desired length of time, stop pressing the SLEEP button.
➜The Sleep Timer is now set. After this amount of time passes, the system will switch to Standby mode.
To deactivate the Sleep Timer
●Press SLEEP repeatedly until "OFF" is displayed, or press the STANDBY ON button.
E n g l i s h
29
pg | 29 | 12/8/00, 1:53 PM 3139 115 20411 |