Troubleshooting
E n g l i s h
TAPE OPERATION/RECORDING
| Recording or playback cannot be made. | – | Clean deck parts, see “Maintenance”. |
|
| – Use only NORMAL (IEC I) or IEC type II (Cr02) | |
|
|
| tape. |
|
| – Apply a piece of adhesive tape over the missing | |
|
|
| tab space. |
| The tape deck door cannot open. | – | Remove and reconnect the AC power plug and |
|
|
| switch on the system again. |
|
|
|
|
| Recorded material sounds strange. | – | Switch off Dolby Pro Logic mode when |
|
|
| recording. |
|
|
|
|
GENERAL |
|
| |
| The system does not react when buttons | – | Remove and reconnect the AC power plug and |
| are pressed. |
| switch on the system again. |
| Sound cannot be heard or poor quality. | – | Adjust the volume. |
|
| – | Disconnect the headphones. |
|
| – Check that the speakers are connected correctly. | |
|
| – Check if the stripped speaker wire is clamped. |
The left and right sound outputs are reversed.
–Check the speaker connections and location.
The remote control does not function properly.
–Select the source (CD or TUNER for example) before pressing the function button (É,í,ë, ).
–Reduce the distance to the system.
–Insert the batteries with their polarities (+/– signs) as indicated.
–Replace the batteries.
–Point in the direction of the system’s sensor.
The timer is not working.
–Set the clock correctly.
–Press the TIMER ON/OFF to switch on the timer.
–If recording is in progress, stop recording.
The sound from the external source is | – | Press AUX to select CDR/DVD mode for |
distorted. |
| listening to the external source. |
Not all lighted buttons are showing light. | – | Press DIM until the DIM OFF display mode is |
|
| shown. |
The Clock/Timer setting is erased.
–Power has been interrupted or the power cord has been disconnected. Reset the clock/timer again.
The system displays features | – Press and hold DEMO STOP Çon the system |
automatically and buttons start flashing. | to switch off the Demonstration. |
|
|
32
pg | 32 | 12/8/00, 1:53 PM 3139 115 20411 |