Philips FW-V720 General Information, Environmental Information, Supplied accessories, English

Models: FW-V720

1 32
Download 32 pages 23.55 Kb
Page 7
Image 7
General Information

General Information

IMPORTANT!

PLEASE NOTE THAT THE VOLTAGE SELECTOR LOCATED AT THE REAR OF THIS SYSTEM IS PRESET AT 220V FROM THE FACTORY. FOR COUNTRIES THAT OPERATE AT 110V-127V, PLEASE ADJUST TO 110V-127V BEFORE YOU SWITCH ON THE SYSTEM.

Environmental Information

All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).

Your system consists of materials which can be recycled and reused if disassembled by a specialised company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.

Supplied accessories

Remote control

Batteries (two AA size) for remote control

AM loop antenna

FM wire antenna

AC power cord

One pair of surround speakers

One Video cinch cable

Safety Information

Before operating the system, check that the operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) of your system is identical with the voltage of your local power supply. If not, please consult your dealer.

Place the system on a flat, hard and stable surface.

Place the system in a location with adequate ventilation to prevent internal heat build-up in your system. Allow at least 10 cm (4 inches) clearance from the rear and the top of the unit and 5 cm (2 inches) from each side.

Do not expose the system, batteries or discs to excessive moisture, rain, sand or heat sources caused by heating equipment or direct sunlight.

If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the disc unit inside the system. Should this occur, the CD player would not operate normally. Leave the power on for about one hour with no disc in the system until normal playback is possible.

The mechanical parts of the set contain self- lubricating bearings and must not be oiled or lubricated.

When the system is switched to Standby mode, it is still consuming some power. To disconnect the system from the power supply completely, remove the AC power plug from the wall socket.

English

7

pg 001-032/V720/21-Eng

7

6/5/01, 6:40 PM

3139 115 20912

Page 7
Image 7
Philips FW-V720 manual General Information, Environmental Information, Supplied accessories, Safety Information, English

FAQ

How do I adjust the voltage on my Philips FW-V720 stereo system?

To adjust the voltage, locate the voltage selector at the rear of the system and switch it to the appropriate setting for your country's power supply.

What materials can be recycled from the packaging of my Philips FW-V720 stereo system?

The packaging materials can be separated into cardboard, polystyrene foam, and polyethylene bags, all of which can be recycled. Be sure to follow local regulations for disposal.

How should I position my Philips FW-V720 stereo system to ensure proper ventilation?

Place the system on a flat, hard, and stable surface with adequate ventilation, allowing at least 10 cm of clearance from the rear and top, and 5 cm from each side to prevent heat build-up.