|
|
| Preparations |
|
|
|
|
C Speakers Connection |
| Inserting batteries into the | |
| Front Speakers |
| Remote Control |
glish
Connect the speaker wires to the SPEAKERS (FRONT) terminals, right speaker to "R" and left speaker to "L", coloured (marked) wire to "+" and black (unmarked) wire to
1 | 2 |
●Fully insert the stripped portion of the speaker wire into the terminal as shown.
Notes:
–For optimal sound performance, use the supplied speakers.
–Do not connect more than one speaker to any one pair of +/- speaker terminals.
–Do not connect speakers with an impedance lower than the speakers supplied. Please refer to the SPECIFICATIONS section of this manual.
DVideo Out Connection
Connect the VIDEO OUT (CVBS) terminal at the rear of the system to the TV or VCR VIDEO IN for viewing or recording.
Note:
– To avoid magnetic interference with the picture on your TV, do not position the front speakers too close to the TV.
EConnecting other equipment to your system
Connect the audio left and right OUT terminals of a TV,VCR, Laser Disc player, DVD player or CD Recorder to the AUX/CDR IN terminals.
Note:
– If you are connecting equipment with a mono output (a single audio out terminal), connect it to the AUX/CDR IN left terminal. Alternatively, you can use a “single to double” cinch cable (still be mono sound).
Insert two batteries (Type R06 or AA) into the remote control with the correct polarity as indicated by the + and - symbols inside the battery compartment.
CAUTION!
–Remove batteries if they are exhausted or not to be used for a long time.
–Do not use old and new or different types of batteries in combination.
–Batteries contain chemical substances, so they should be disposed off properly.
En
9
pg | 9 | 12/11/01, 5:15 PM 3139 115 21143 |
